This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Experiments and Analysis of Diesel Particulate Filter Loading and Regeneration
Technical Paper
2000-01-3087
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Experimental measurements of diesel particulate filter (DPF) soot loading and regeneration have been performed with an engine test cell and a laboratory flow reactor. In the test cell experiments, platinum-catalyzed and non-catalyzed filters were loaded with particulate matter emitted from a 7.3-l engine. Regeneration was initiated in two different ways: increasing engine load or with fuel injection upstream of the filter. The flow reactor used loaded filters from the test cell, which were regenerated at three temperatures and two space velocities.
The catalyzed filter showed faster regeneration than the non-catalyzed filter in the engine test cell. Fuel injection was shown to be an effective regeneration initiator. Flow reactor results confirmed that the soot oxidation rate is strongly temperature dependent and that at temperatures between 400 and 700 °C can be characterized by an Arrhenius-type expression. The catalytic coating led to soot oxidation rates that were between 6 and 16 times higher than that of the uncoated DPF, and halved the activation energy. Approximate activation energies of 38 kJ/mol and 85 kJ/mol for the catalyzed and uncatalyzed DPFs, respectively, were obtained at space velocities of 35,000 and 70,000 hr-1, 18% O2, and NOx levels below 30 ppm.
Recommended Content
Authors
Citation
Edgar, B., Balakrishnan, K., Zhou, X., and Rumminger, M., "Experiments and Analysis of Diesel Particulate Filter Loading and Regeneration," SAE Technical Paper 2000-01-3087, 2000, https://doi.org/10.4271/2000-01-3087.Also In
References
- Awara, A.E. Opris, C.N. Johnson, J.H. 1997 “A theoretical and experimental study of the regeneration process in a silicon carbide particulate trap using a copper fuel additive” SAE paper 970188
- Bouchez, M. Dementhon, J.B. 2000 “Strategies for the control of particulate trap regeneration” SAE paper 2000-01-0472
- Diesel Exhaust Aftertreatment SAE Special Publication 1997 1998 1999 2000
- Jelles, S.J. Krul, R.R. Makkee, M. Moulijn, J.A. 1999 “The influence of NO x on the oxidation of metal activated diesel soot” Catalysis Today 53 623 630
- Johnson, J.H. Bagley, S.T. Gratz, L. D. Leddy, D. G. 1994 “A review of diesel particulate control technology and emissions effects - 1992 Horning memorial award lecture” SAE Paper 940233
- Konstandopoulos, A.G. Kostoglou, M. Skaperdas, E. Papaioannou, E. Zarvalis, D. Kladopoulou, E. 2000 “fundamental studies of diesel particulate filters: transient loading, regeneration and aging” SAE paper 2000-01-1016
- Mul, G. Zhu, W.D. Kapteijn, F. Moulijn, J.A. 1998 “The effect of NO x and CO on the rate of transition metal oxide catalyzed carbon black oxidation: An exploratory study” Applied Catalysis B: Environmental 17 205 220
- Neeft, J.P.A. Makkee, M. Moulijn, J.A. 1996 “Catalysts for the oxidation of soot from diesel exhaust gases. I. An Exploratory Study” Applied Catalysis B: Environmental 8 57 78
- Neeft, J.P.A. van Pruissen, O.P. Makkee, M. Moulijn, J.A. 1997 “Catalysts for the oxidation of soot from diesel exhaust gases. II. Contact between soot and catalyst under practical conditions” Applied Catalysis B: Environmental 12 21 31
- Otto, K. Seig, M.H. Zinbo, M. Bartosiewicz, L. 1980 “The oxidation of soot deposits from diesel engines” SAE Paper 800336
- Page, D.L. MacDonald, R.J. Edgar, B.L. 1999 “The QuadCAT four-way catalytic convertor: an integrated aftertreatment system for diesel engines” SAE paper 1999-01-2924
- Pauli, E. Lepperhoff, G. Pischinger, F. 1983 “The description of the regeneration behavior of diesel particulate traps with the aid of a mathematical model” SAE Paper 830180
- Uchisawa, J.O. Obuchi, A. Zhao, Z. Kushiyama, S. 1998 “Carbon oxidation with platinum supported catalysts” Applied Catalysis B: Environmental 18 L183 L187
- Uchisawa, J.O. Obuchi, A. Ogata, A. Enomoto, R. Kushiyama, S. 1999 “Effect of feed gas composition on the rate of carbon oxidation with Pt/SiO2 and the oxidation mechanism” Applied Catalysis B: Environmental 21 9 17
- Uchisawa, J.O. Obuchi, A. Enomoto, R. Liu, S.T. Nanba, T. Kushiyama, S. 2000 “Catalytic performance of Pt supported on various metal oxides in the oxidation of carbon black” Applied Catalysis B: Environmental 26 17 24
- Versaevel, P. Colas, H. Rigaudeau, C. Noirot, R. Koltsakis, G.C. Stamatelos, A.M. 2000 “Some empirical observations on diesel particulate filter modeling and comparison between simulations and experiments” SAE paper 2000-01-0477