This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Design Analysis of Typical Injection Transfer Moulding Faults
Technical Paper
1999-01-0880
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The paper shows how processing parameters of an injection transfer-moulding machine can be controlled to create and identify moulding faults of valve-stem seals. By controlling the processing parameters to produce typical valve-stem seal moulding faults at the system design stage, causes for waste can be identified.
Detailed knowledge of the manufacturing process is fed into a knowledge based SPC quality system to monitor and control the manufacturing process. This information is used in the manufacture of valve-stem seals to improve quality and reduce waste.
Recommended Content
Authors
Citation
Ngo, B., Fern, A., Coverdale, N., Krabbe, P. et al., "Design Analysis of Typical Injection Transfer Moulding Faults," SAE Technical Paper 1999-01-0880, 1999, https://doi.org/10.4271/1999-01-0880.Also In
References
- Antony, J. Kaye, M. Key interactions Manufacturing Engineer IEE 1998
- Krabbe, P.M. Ngo, B. Fern, A.G. Drake, P.R. Pham, D.T. An Automated Manufacturing System for Valve-stem Seals including 100% Automated Visual Inspection 31 st ISATA International Symposium on Automotive Technology and Automation Duesseldorf, Germany June 2-5 1998
- Ngo, B. Fern, A.G. Krabbe, P.M. Pham, D.T. Drake, P.R. Expert knowledge based SPC quality system 31 st ISATA International Symposium on Automotive Technology and Automation Duesseldorf, Germany June 2-5 1998
- Bendell, A. Disney, J. Pridmore, W.A. Taguchi Methods IFS publications Springer-Verlag 1989
- Pham, D.T. Oztemel, E. Intelligent quality systems Springer-Verlag 1996
- Mason-Jones, A. Fern, A.G. Wang, J. Pham, D.T. Design and life performance of valve stem seals SAE 1999