This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Roll-Over Protective Structures (ROPS) for Wheeled Agricultural Tractors
- Ground Vehicle Standard
- J2194_198712
- Issued
Sector:
Issuing Committee:
Language:
English
Scope
Any ROPS meeting the performance requirement of ISO 5700 (Static ROPS Test Standard) or ISO 3463 (Dynamic ROPS Test Standard) meets the performance requirements of this SAE Standard if the ROPS temperature/material and seat belt requirements of this document are also met.
Fulfillment of the intended purpose requires testing as follows:
A temperature-material requirement (6.9). This can be satisfied by using the appropriate materials or by performing any of the structural performance tests (Sections 7, 8, or 9) at -18 °C.
A laboratory test, under repeatable and controlled loading, to permit analysis of the ROPS for compliance with the performance requirements of this document. Either the static test sequence (Section 7) or the impact test sequence (Section 8 ) shall be conducted. See Figure 1.
A seat belt anchorage test (Section 10).
The test procedures and performance requirements outlined in this document are based on currently available engineering data.
Recommended Content
| Technical Paper | Development of ROPS Criteria for Construction and Industrial Vehicles |
| Ground Vehicle Standard | Performance Prediction of Roll-Over Protective Structures (Rops) Through Analytical Methods |
| Ground Vehicle Standard | Roll-Over Protective Structures (ROPS) for Wheeled Agricultural Tractors |
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Reference
| Number | Title |
|---|
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.