This content is not included in your SAE MOBILUS subscription, or you are not logged in.
High-Temperature Power Steering Pressure Hose
- Ground Vehicle Standard
Published April 02, 2001 by SAE International in United States
This SAE Standard covers two types of hose fabricated from textile reinforcement and synthetic rubber, assembled with end fittings for use in high-temperature automotive power steering applications as flexible connections within the temperature range of -40 to +150 °C (-40 to +302 °F) maximum and 10.3 MPa (1500 psi) maximum working pressure. These hoses are intended for use in applications where reduction in amplitude of pump pressure pulsation is required. Class A hose has a nominal OD of 19.84 mm (0.781 in). Class B hose is a lightweight hose with a nominal OD of 17.91 mm (0.705 in). This specification defines the minimum performance levels of a flexible connector in the hydraulic steering system to convey power steering fluid from the steering pump to the steering gear.
|Ground Vehicle Standard||High-Temperature Power Steering Pressure Hose|
|Technical Paper||Measurement of Fluid Bulk Modulus Using Impedance of Hydraulic Circuits|
|Technical Paper||Determining Source Fluidborne Noise Characteristics of Automotive Fluid Power Pumps|
Data Sets - Support Documents
No Datasets Available
Automotive Brake and Steering Hose Standards Comm
Provide and maintain uniform standards, recommended practices, and information reports to reflect changing needs while maximizing the safety and performance of Hydraulic Brake, Vacuum Brake, and Power Steering Hose and Hose Assemblies. This shall be done in a manner that will encourage productivity and cost containment while facilitating the ever-expanding global interchange and market.
|ASTMD380||This document is not part of the subscrption.|
|ASTMD413||This document is not part of the subscrption.|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.