This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
AGING OF PELLETED AND MONOLITHIC AUTOMOTIVE EMISSION CONTROL CATALYSTS
Annotation ability available
Sector:
Language:
English
Abstract
Experimental dual bed pelleted and monolithic automotive emission control catalysts were prepared and aged on an engine-dynamometer under identical conditions. The catalysts contained the same noble metal loadings and had the same noble metal ratios.
The warmed-up conversion performance was obtained for both the front bed catalyst only and for the two catalyst beds in combination. The contaminant pickups and penetrations into the pellets were also measured.
Recommended Content
Authors
Topic
Citation
Summers, J. and Thompson, C., "AGING OF PELLETED AND MONOLITHIC AUTOMOTIVE EMISSION CONTROL CATALYSTS," SAE Technical Paper 800842, 1980, https://doi.org/10.4271/800842.Also In
References
- Shelef M. Otto K. Otto N. C. “Poisoning of Automotive Catalysts,” Advances in Catalysis 27 311 1979
- Wei J. “Catalysis for Motor Vehicle Emissions,” Advances in Catalysis 24 57 1975
- Engh G. T. Wallman S. “Development of the Volvo Lambda-Sond System,” 1977
- Jackson M. W. “Effect of Catalytic Emission Control on Exhaust Hydrocarbon Composition and Reactivity,” 1978
- Wotring W. T. Meguerian G. H. Gandhi H. S. McCuiston F. D. Piken A. G. “50,000 Mile Vehicle Road Test of Three-Way and NOx Reduction Catalyst Systems,” 1978
- Mooney J. J. Thompson C. E. Dettling J. C. “Three-Way Conversion Catalysts: Part of the New Emission Control System,” 1977
- Oeser P. “Catalyst Systems with an Emphasis on Three-Way Conversion and Novel Concepts,” 1979
- Falk C. D. Mooney J. J. “Three-Way Conversion Catalysts: Effect of Closed-Loop Feed Back Control and Other Parameters on Catalyst Efficiency,” 1980
- Adomaitis J. R. Smith J. E. Achey D. E. “Improved Pelleted Catalyst Substrates for Automotive Emissions Control,” 1980
- Gandhi H. S. Piken A. G. Shelef M. Delosh R. G. “Laboratory Evaluation of Three-Way Catalysts,” 1976
- Summers J. C. Baron K. “The Effects of SO 2 on the Performance of Noble Metal Catalysts in Automobile Exhaust,” Journal of Catalysis 57 380 1979
- Caracciolo F. Spearot J. A. “Engine Oil Additive Effects on the Deterioration of a Stoichiometric Emissions Control (C-4) System,” 1979
- Summers J. C. Monroe D. R. “Design Factors of Dual Bed Catalysts,” September 1979
- Hegedus L. L. Summers J. C. Schlatter J. C. Baron K. “Poison-Resistant Catalysts for the Simultaneous Control of Hydrocarbon, Carbon Monoxide, and Nitrogen Oxide Emissions,” Journal of Catalysis 56 321 1979
- Herod D. M. Nelson M. V. Wang W. M. “An Engine Dynamometer System for the Measurement of Converter Performance,” 1973
- Summers J. C. Hegedus L. L. “Modes of Catalyst Deactivation in Stoichiometric Automobile Exhaust,” I&EC Product Research & Development 18 318 1979
- Summers J. C. Monroe D. R. Chang C. C. Gaarenstroom S. W. “Regeneration of Three-Way Catalysts,” November 1979
- Chou T. S. Hegedus L. L. “Transient Diffusivity Measurements in Catalyst Pellets with Two Zones of Differing Diffusivities,” AICHE Journal 24 255 1978
- Hegedus L. L. Summers J. C. “Improving the Poison Resistance of Supported Catalysts,” Journal of Catalysis 48 345 1977
- Shelef M. Dalla Betta R. A. Larson J. A. Otto K. Yao H. C. “Poisoning of Monolithic Noble Metal Oxidation Catalysts in Automotive Exhaust Environment,” presented at the symposium “Catalyst Poisoning” of the 74th National Meeting of AICHE March 11–15 1973