This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Emission Control by Engine Design and Development
Annotation ability available
Sector:
Language:
English
Abstract
Requirements of federal and state agencies to control the exhaust emissions of motor vehicles defined performance standards for 1968. Consideration of economics and practicality motivated a full scale design and development program to meet this required performance without the use of a secondary control system. An analysis of new low quench type combustion chambers compared with the standard chambers used on two displacements of a 6-cylinder engine family in prior model years is presented in terms of parameters related to exhaust emission and to conventional engine design.
The engine induction system, with special emphasis on carburetor characteristics, is contrasted for application to non-emission controlled engines with application to emission controlled engines.
Recommended Content
Citation
Hittler, D. and Hamkins, L., "Emission Control by Engine Design and Development," SAE Technical Paper 680110, 1968, https://doi.org/10.4271/680110.Also In
References
- “The Clean Air Act.” December 17 1963 October 20 1965
- “Standards for Ambient Air and Motor Vehicle Exhausts.” The State of California December 4 1959
- Potter D. V. Leydorf, G. F. Jr. Lawler R. L. “The New Rambler Six Engine - Torque Command 232.” Paper 884B SAE Summer Meeting Chicago June 1964
- Beckman E. W. Fagley, W S. Jr. Sarto J. O. “Exhaust Emission Control by Chrysler The Cleaner Air Pack age.” Paper 660107 SAE Automotive Engineering Congress Detroit January 1966
- Fagley, W. S. Jr. Sink Mark V. Heinen C. M. “Maintenance and the Automobile Exhaust - Second Report.” Paper No. 486L SAE National Automobile Week Detroit, Michigan March 1962
- Bartholomew Earl “Potentialities of Emission Reduction by Design of Induction Systems.” Paper No. 660109 SAE Automotive Engineering Congress Detroit January 1966
- Jones J. H. Gagliardi J. C. “Vehicle Exhaust Emission Experiments Using a Pre-Mixed and Pre-Heated Air Fuel Charge.” Paper 670485 SAE Mid-Year Meeting Chicago May 1967
- Scheffler C.E. “Combustion Chamber Surface Area, A Key to Exhaust Hydrocarbons.” Paper 660111 SAE Automotive Engineering Congress Detroit January 1966
- Cook F. W. “Antismog Carburetor Hardware and Test Equipment.” Paper 660110 SAE Automotive Engineering Congress Detroit January 1966
- Federal Register 31 61 “Control of Air Pollution From New Motor Vehicles and New Motor Vehicle Engines.” Washington, D. C. March 1966
- Rabezzana H. Kalmar S. Candeliste A. “Combustion: An Analysis of Burning and Expansion In The Reaction Zone.” Automobile Engineer 29 1939 347 377
- Patterson D. J. Van Wylen G. “A Digital Computer Simulation for Spark-Ignited Engine Cycles.” SAE Progress in Technology 7 “Digital Calculations of Engine Cycles.” New York Society of Automotive Engineers, Inc. 1964
- Taub A “Method and Machine for Avoiding Combustion Chamber Calculations.” SAE Journal 36 4 April 1935 159
- Gagliardi J. C. “The Effect of Fuel Anti-Knock Compounds and Deposits on Exhaust Emissions.” Paper 670128 SAE Automotive Engineering Congress Detroit January 1967
- Huls T. A. Myers P. S. Uyrehara O. A. “Spark Ignition Engine Operation and Design for Minimum Exhaust Emission” Paper 660405 SAE Mid-Year Meeting Detroit June 1966