This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Autoignition of Isooctane beyond RON and MON Conditions
ISSN: 1946-3952, e-ISSN: 1946-3960
Published April 03, 2018 by SAE International in United States
Citation: Masurier, J., Waqas, M., Sarathy, M., and Johansson, B., "Autoignition of Isooctane beyond RON and MON Conditions," SAE Int. J. Fuels Lubr. 11(4):459-468, 2018, https://doi.org/10.4271/2018-01-1254.
The present study experimentally examines the low-temperature autoignition area of isooctane within the in-cylinder pressure-in-cylinder temperature map.
Experiments were run with the help of a Cooperative Fuel Research (CFR) engine. The boundaries of this engine were extended so that experiments could be performed outside the domain delimited by research octane number (RON) and motor octane number (MON) traces. Since homogeneous charge compression ignition (HCCI) combustion is governed by kinetics, the rotation speed for all the experiments was set at 600 rpm to allow time for low-temperature heat release (LTHR). All the other parameters (intake pressure, intake temperature, compression ratio, and equivalence ratio) were scanned, such as the occurrence of isooctane combustion.
The principal results showed that LTHR for isooctane occurs effortlessly under high intake pressure (1.3 bar) and low intake temperature (25 °C). Increasing the intake temperature leads to the loss of the LTHR and therefore to a smaller domain on the pressure-temperature trace. In such a case, the LTHR domain is restricted from 20 to 50 bar in pressure and from 600 to 850 K in temperature. By slightly decreasing the intake pressure, the LTHR domain remains unchanged, but the LTHR tends to disappear, and finally, at 1.0 bar, the LTHR domain ceases to exist. When the equivalence ratio is moved from 0.3 to 0.4, the LTHR domain is delimited in the same range of pressure and temperature, but the start of combustion occurs slightly earlier for the same pressure-temperature trace. Similar conclusions were drawn regarding the variation of both intake pressure and temperature, except that few LTHR points were observed under 1.0 bar intake.
|Technical Paper||A Computational Investigation into the Cool Flame Region in HCCI Combustion|
|Technical Paper||Comparison of HCCI Operating Ranges for Combinations of Intake Temperature, Engine Speed and Fuel Composition|