This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Understanding the Dynamic Evolution of Cyclic Variability at the Operating Limits of HCCI Engines with Negative Valve Overlap

Journal Article
2012-01-1106
ISSN: 1946-3936, e-ISSN: 1946-3944
Published April 16, 2012 by SAE International in United States
Understanding the Dynamic Evolution of Cyclic Variability at the Operating Limits of HCCI Engines with Negative Valve Overlap
Sector:
Citation: Hellström, E., Stefanopoulou, A., Vavra, J., Babajimopoulos, A. et al., "Understanding the Dynamic Evolution of Cyclic Variability at the Operating Limits of HCCI Engines with Negative Valve Overlap," SAE Int. J. Engines 5(3):995-1008, 2012, https://doi.org/10.4271/2012-01-1106.
Language: English

References

  1. Law, D. Kemp, D. Allen, J. Kirkpatrick, G. et al. “Controlled Combustion in an IC-Engine with a Fully Variable Valve Train,” SAE Technical Paper 2001-01-0251 2001 10.4271/2001-01-0251
  2. Thring, R. “Homogeneous-Charge Compression-Ignition (HCCI) Engines,” SAE Technical Paper 892068 1989 10.4271/892068
  3. Koopmans, L. Denbratt, I. “A Four Stroke Camless Engine, Operated in Homogeneous Charge Compression Ignition Mode with Commercial Gasoline,” SAE Technical Paper 2001-01-3610 2001 10.4271/2001-01-3610
  4. Olsson, J. Tunestål, P. Johansson, B. Fiveland, S. et al. “Compression Ratio Influence on Maximum Load of a Natural Gas Fueled HCCI Engine,” SAE Technical Paper 2002-01-0111 2002 10.4271/2002-01-0111
  5. Koopmans, L. Backlund, O. Denbratt, I. “Cycle to Cycle Variations: Their Influence on Cycle Resolved Gas Temperature and Unburned Hydrocarbons from a Camless Gasoline Compression Ignition Engine,” SAE Technical Paper 2002-01-0110 2002 10.4271/2002-01-0110
  6. Karagiorgis, S. Collings, N. Glover, K. Coghlan, N. et al. “Residual Gas Fraction Measurement and Estimation on a Homogeneous Charge Compression Ignition Engine Utilizing the Negative Valve Overlap Strategy,” SAE Technical Paper 2006-01-3276 2006 10.4271/2006-01-3276
  7. Sjöberg, M. Dec, J. Babajimopoulos, A. Assanis, D. “Comparing Enhanced Natural Thermal Stratification Against Retarded Combustion Phasing for Smoothing of HCCI Heat-Release Rates,” SAE Technical Paper 2004-01-2994 2004 10.4271/2004-01-2994
  8. Blom, D. Karlsson, M. Ekholm, K. Tunestål, P. et al. “HCCI Engine Modeling and Control using Conservation Principles,” SAE Technical Paper 2008-01-0789 2008 10.4271/2008-01-0789
  9. Willand, J. Nieberding, R. Vent, G. Enderle, C. “The Knocking Syndrome - Its Cure and Its Potential,” SAE Technical Paper 982483 1998 10.4271/982483
  10. Persson, H. Pfeiffer, R. Hultqvist, A. Johansson, B. et al. “Cylinder-to-Cylinder and Cycle-to-Cycle Variations at HCCI Operation With Trapped Residuals,” SAE Technical Paper 2005-01-0130 2005 10.4271/2005-01-0130
  11. Jungkunz, A. F. Liao, H.-H. Ravi, N. Gerdes, J. C. Reducing combustion variation of late-phasing HCCI with cycle-to-cycle exhaust valve timing control IFAC Symp. on Advances in Automotive Control 2010
  12. Jungkunz, A. F. Liao, H.-H. Ravi, N. Gerdes, J. C. Combustion phasing variation reduction for late-phasing HCCI through cycle-to-cycle pilot injection timing control Proc. of the ASME Dynamic Systems and Control Conference 2011
  13. Wagner, R. Edwards, K. Daw, C. Green, J. et al. “On the Nature of Cyclic Dispersion in Spark Assisted HCCI Combustion,” SAE Technical Paper 2006-01-0418 2006 10.4271/2006-01-0418
  14. Daw, C. S. Wagner, R. M. Edwards, K. D. Green, J. B. Jr. Understanding the transition between conventional spark-ignited combustion and HCCI in a gasoline engine Proc. Combust. Inst. 31 2 2887 2894 2007
  15. Ghazimirsaied, A. Shahbakhti, M. Koch, C.R. HCCI engine combustion phasing prediction using a symbolic-statistics approach J. Eng. Gas Turbines Power 132 8 082805 2010
  16. Sjöberg, M. Dec, J.E. Comparing late-cycle autoignition stability for single- and two-stage ignition fuels in HCCI engines Proc. Combust. Inst. 31 2 2895 2902 2007
  17. Xingcai, L. Libin, J. Junjun, M. Zhen, H. Experimental study on the cycle-by-cycle variations of homogeneous charge compression ignition combustion using primary reference fuels and their mixtures Proc. Inst. Mech. Eng. Part D 221 7 859 866 2007
  18. Shahbakhti, M. Koch, C.R. Characterizing the cyclic variability of ignition timing in a homogeneous charge compression ignition engine fuelled with n-heptane/iso-octane blend fuels Int. J. Engine Res. 9 5 361 397 2008
  19. Chiang, C.J. Stefanopoulou, A. G. Stability analysis in homogeneous charge compression ignition (HCCI) engines with high dilution IEEE Trans. Control Syst. Technol. 15 2 209 219 2007
  20. Kang, J. “Sensitivity Analysis of Auto-ignited Combustion in HCCI Engines,” SAE Technical Paper 2010-01-0573 2010 10.4271/2010-01-0573
  21. Koopmans, L. Ström, H. Lundgren, S. Backlund, O. et al. “Demonstrating a SI-HCCI-SI Mode Change on a Volvo 5-Cylinder Electronic Valve Control Engine,” SAE Technical Paper 2003-01-0753 2003 10.4271/2003-01-0753
  22. Urushihara, T. Hiraya, K. Kakuhou, A. Itoh, T. “Expansion of HCCI Operating Region by the Combination of Direct Fuel Injection, Negative Valve Overlap and Internal Fuel Reformation,” SAE Technical Paper 2003-01-0749 2003 10.4271/2003-01-0749
  23. Song, H.H. Padmanabhan, A. Kaahaaina, N. B. Edwards, C.F. Experimental study of recompression reaction for low-load operation in direct-injection homogeneous charge compression ignition engines with n-heptane and i-octane fuels Int. J. Engine Res. 10 4 215 229 2009
  24. Wermuth, N. Yun, H. Najt, P. “Enhancing Light Load HCCI Combustion in a Direct Injection Gasoline Engine by Fuel Reforming During Recompression,” SAE Int. J. Engine 2 1 823 836 2009 10.4271/2009-01-0923
  25. Knierim, K.L. Park, S. Ahmed, J. Kojic, A. Orlandini, I. Kulzer, A. Simulation of misfire and strategies for misfire recovery of gasoline HCCI Proc. American Control Conf. 3947 3952 2008
  26. Mayhew, C.G. Knierim, K.L. Chaturvedi, N.A. Park, S. Ahmed, J. Kojic, A. Reduced-order modeling for studying and controlling misfire in four-stroke HCCI engines Proc. 48th IEEE Conf. on Decision and Control 5194 5199 2009
  27. Manofsky, L. Vavra, J. Assanis, D. Babajimopoulos, A. “Bridging the Gap between HCCI and SI: Spark-Assisted Compression Ignition,” SAE Technical Paper 2011-01-1179 2011 10.4271/2011-01-1179
  28. Daw, C.S. Edwards, K.D. Wagner, R.M. Jr. Green, J.B. Modeling cyclic variability in spark-assisted HCCI J. Eng. Gas Turbines Power 130 5 052801 2008
  29. Saxena, S. Chen, J. Dibble, R. “Maximizing Power Output in an Automotive Scale Multi-Cylinder Homogeneous Charge Compression Ignition (HCCI) Engine,” SAE Technical Paper 2011-01-0907 2011 10.4271/2011-01-0907
  30. Mo, Y. HCCI heat release rate and combustion efficiency: A coupled KIVA multi-zone modeling study PhD thesis University of Michigan 2008
  31. Hellström, E. Stefanopoulou, A. G. Modeling cyclic dispersion in autoignition combustion Proc. 50th IEEE Conf. on Decision and Control 6834 6839 2011
  32. Heywood, J.B. Internal Combustion Engine Fundamentals McGraw-Hill 1988
  33. Chang, J. Güralp, O. Filipi, Z. Assanis, D. et al. “New Heat Transfer Correlation for an HCCI Engine Derived from Measurements of Instantaneous Surface Heat Flux,” SAE Technical Paper 2004-01-2996 2004 10.4271/2004-01-2996
  34. Babajimopoulos, A. P. Challa, V. S. S. Lavoie, G. A. Assanis, D. Model-based assessment of two variable cam timing strategies for HCCI engines: Recompression vs. rebreathing Proc. ASME Internal Combust. Engine Div. Spring Tech. Conf. 2009
  35. Eriksson, L. “CHEPP - A Chemical Equilibrium Program Package for Matlab,” SAE Technical Paper 2004-01-1460 2004 10.4271/2004-01-1460
  36. Fitzgerald, R. Steeper, R. Snyder, J. Hanson, R. et al. “Determination of Cycle Temperatures and Residual Gas Fraction for HCCI Negative Valve Overlap Operation,” SAE Int. J. Engines 3 1 124 141 2010 10.4271/2010-01-0343
  37. Ortiz-Soto, E. A. Vávra, J. Babajimopoulos, A. Assessment of residual mass estimation methods for cylinder pressure heat release analysis of HCCI engines with negative valve overlap Proc. ASME Internal Combust. Engine Div. Fall Tech. Conf. 2011

Cited By