This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Quantifying Uncertainty in Vehicle Simulation Studies

Journal Article
ISSN: 1946-3995, e-ISSN: 1946-4002
Published April 16, 2012 by SAE International in United States
Quantifying Uncertainty in Vehicle Simulation Studies
Citation: Geller, B. and Bradley, T., "Quantifying Uncertainty in Vehicle Simulation Studies," SAE Int. J. Passeng. Cars - Mech. Syst. 5(1):381-392, 2012,
Language: English


  1. Faron, G. Pagerit, S. Rousseau, A. “Evaluation of PHEV's Fuel Efficiency and Cost Using Monte Carlo Analysis,” EVS24 2009
  2. Geller, B. “Increased Understanding of Hybrid Vehicle Design through Modeling, Simulation, and Optimization,” M.S. Thesis Department of Mechanical Engineering, Colorado State University 2010
  3. Golbuff, S. “Optimization of a Plug-in Hybrid Electric Vehicle,” M.S. Thesis Department of Mechanical Engineering, Georgia Institute of Technology 2006
  4. Delorme, A. Pagerit, S. Sharer, P. Rousseau, A. “Cost Benefit Analysis of Advanced Powertrains from 2010 to 2045,” EVS24 Argonne National Laboratory 2009
  5. Bradley, T.H. Frank, A.A. “Design, Demonstration, and Sustainability Impact Assessments for Plug-in Hybrid Electric Vehicles,” Renewable & Sustainable Energy Reviews Elsevier 2007
  6. Fellini, R. Michelena, N. Papalambros, P. Sasena, M. “Optimal Design of Hybrid Powertrain Systems,” University of Michigan Ann Arbor, Michigan 1998
  7. Xu, J-W. Zheng, L. “Simulation and Analysis of Series Hybrid Electric Vehicle Based on ADVISOR,” 2010 International Conference on Measuring Technology and Mechatronics Automation 2010
  8. Senger, R.D. “Validation of ADVISOR as a Simulation Tool for a Series Hybrid Electric Vehicle Using the Virginia Tech FutureCar Lumina,” M.S. Thesis Department of Mechanical Engineering, Virginia Polytechnic Institute and State University 1998
  9. Wipke, K.B. Cuddy, M.R. “Using an Advanced Vehicle Simulator (ADVISOR) to Guide Hybrid Vehicle Propulsion System Development,” National Renewable Energy Laboratory 1996
  10. Kellermeyer, W.F. “Development and Validation of a Modular Hybrid Electric Vehicle Simulation Model,” M.S. Thesis Department of Mechanical Engineering, West Virginia University 1998
  11. Schmitt, K. Madsen, J. Anitecsu, M. Negrut, D. “A Gaussian-Process Based Approach to Handling Uncertainty in Vehicle Dynamic Simulations,” Proceedings of IMECE2008, IMECE2008-66664 2008
  12. Datar, M.V. “Uncertainty Quantification in Ground Vehicle Dynamics through High Fidelity Co-Simulation,” M.S. Thesis Department of Mechanical Engineering, University of Wisconsin - Madison 2008
  13. Gopal, R.V. Rousseau, A. “System Analysis Using Multiple Expert Tools,” SAE Technical Paper 2011-01-0754 2011 10.4271/2011-01-0754
  14. Jones, S. “System Simulation Tools for Electrified Vehicles,” Joint EC/EPoSS/ERTRAC Expert Workshop in Berlin 2011
  15. Kwon, J. Rousseau, A. Sharer, P. “Analyzing the Uncertainty in the Fuel Economy Prediction for the EPA MOVES Binning Methodology,” SAE Technical Paper 2007-01-0280 2007 10.4271/2007-01-0280
  16. Brooker, A. Thornton, M. Rugh, J. “Technology Improvement Pathways to Cost-effective Vehicle Electrification,” SAE Technical Paper 2010-01-0824 2010 10.4271/2010-01-0824
  17. Wilkins, S. Lamperth, M.U. “An Object Oriented Modeling Tool of Hybrid Powertrains for Vehicle Performance Simulation,” Imperial College of Science, Technology and Medicine London 2003
  18. Rahman, Z. Butler, K.L. Ehsani, M. “Designing Parallel Hybrid Electric Vehicles Using V-ELPH 2.01,” Proceedings of the American Control Conference San Diego, California 1999
  19. Aceves, S. Smith, J. “A Hybrid Vehicle Evaluation Code and Its Application to Vehicle Design,” SAE Technical Paper 950491 1995 10.4271/950491
  20. Simpson, A.G. “Parametric Modeling of Energy Consumption in Road Vehicles,” Ph.D. Thesis School of Information Technology and Electrical Engineering, The University of Queensland Australia 2005
  21. Powell, B.K. Pilutti, T.E. “A Range Extender Hybrid Electric Vehicle Dynamic Model,” Proceedings of the 33 rd Conference on Decision and Control 1994
  22. Gao, D.W. Mi, C. Emadi, A. “Modeling and Simulation of Electric and Hybrid Vehicles,” Invited Paper, IEEE 95 4 2007
  23. Thunnissen, D.P. “Uncertainty Classification for the Design and Development of Complex Systems,” California Institute of Technology 2003
  24. Oberkampf, W.L. DeLand, S.M. Rutherford, B.M. Diegert, K.V. Alvin, K.F. “Estimation of Total Uncertainty in Modeling and Simulation,” Sandia Report Sandia National Laboratory SAND2000-0824 2000
  25. Pukrushpan, J.T. “Modeling and Control of Fuel Cell Systems and Fuel Processors,” Ph.D. Thesis Department of Mechanical Engineering, The University of Michigan 2003
  26. Koprubasi, K. “Modeling and Control of a Hybrid-Electric Vehicle for Drivability and Fuel Economy Improvements,” Ph.D. Thesis Department of Mechanical Engineering, The Ohio State University 2008
  27. Oberkampf, W.L. Trucano, T.G. Hirsch, C. “Verification, Validation, and Predictive Capability in Computational Engineering and Physics,” Johns Hopkins University/Applied Physics Laboratory 2002
  28. Echter, N. “Parallel Hydraulic Pressure Assist/Work Circuit Hybrids for Automated Side Loader Refuse Vehicles,” M.S. Thesis Department of Mechanical Engineering, Colorado State University 2012
  29. Liu, L. Felgner, F. Frey, G. “Comparison of 4 Numerical Solvers for Stiff and Hybrid Systems Simulation,” Chari of Automation Saarland University Saarbrucken, Germany IEEE 2010
  30. Cuddy, M. “A comparison of Modeled and Measured Energy Use in Hybrid Electric Vehicles,” National Renewable Energy Laboratory NREL/TP-473-7444 1995
  31. Bruggemann, H. Kiencke, U. “Uncertainty Theory in Vehicle Dynamic Simulation,” Proceedings of the American Control Conference 2002
  32. Petersheim, M.D. Brennan, S.N. “Scaling of Hybrid Electric Vehicle Powertrain Components for Hardware-in-the-Loop Simulation,” 17 th IEEE International Conference on Controls Applications 2008
  33. Rebba, R. Huang, S. Liu, Y. Mahadevan, S. “Statistical Validation of Simulation Models,” Int. J. Materials and Product Technology 2004
  34. Sharer, P. Rousseau, A. Nelson, P. Pagerit, S. “Vehicle Simulation Results for Plug-in HEV Battery Requirements,” Argonne National Laboratory 2006
  35. He, X. Hodgson, J.W. “Modeling and Simulation for Hybrid Electric Vehicles - Part 1: Modeling,” IEEE Transactions on Intelligent Transportation Systems 3 4 2002
  36. Hofman, T. Steinbuch, M. van Druten, R.M. “Modeling and Simulation of Hybrid Drivetrain Components,” Technische Universiteit Eindhoven Netherlands 2001
  37. Wang, B. Lou, Y. “AVL Cruise-based Modeling and Simulation of EQ6110 Hybrid Electric Public Bus,” 2010 International Conference on Computer Application and System Modeling 2010
  38. Demirdoven, N. Deutch, J. “Hybrid Cars Now, Fuel Cell Cars Later,” Science 305 974 2004
  39. Wu, X. Cao, B. Li, X. Xu, J. Ren, X. “Component Sizing Optimization for Plug-in Hybrid Electric Vehicles,” Journal of Applied Energy Elsevier 2010
  40. Gao, W. “Performance Comparison of a Fuel Cell-Battery Hybrid Powertrain and a Fuel Cell-Ultracapacitor Hybrid Powertrain,” IEEE Transactions on Vehicular Technology 54 3 2005
  41. Sangtarash, F. Esfahanian, V. Nehzati, H. Haddadi, S. et al. “Effect of Different Regenerative Braking Strategies on Braking Performance and Fuel Economy in a Hybrid Electric Bus Employing CRUISE Vehicle Simulation,” SAE Int. J. Fuels Lubr. 1 1 828 837 2009 10.4271/2008-01-1561
  42. Ye, X. Jin, Z. Liu, B. Chen, M. Lu, Q. “Design and Application of Parallel Hybrid Vehicle Simulation Platform,” State Key Laboratory of Automotive Safety and Energy Tsinghua University Bejing, China 2008
  43. Geller, B. Bradley, T. “Objective Comparison of Hybrid Vehicles through Simulation Optimization,” SAE Technical Paper 2011-01-0943 2011 10.4271/2011-01-0943
  44. Cao, Q. Pagerit, S. Carlson, R. Rousseau, A. “PHEV Hymotion Prius Model Validation and Control Improvements,” Argonne National Laboratory 2007

Cited By