This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Dynamic Simulation and Endurance Limit Safety Factor Calculation for Crankshaft - Comparison of Single Mass and Dual Mass Flywheel
Technical Paper
2008-01-2622
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The crankshaft is the component which transmits dynamical loading from cylinder pressure and inertial loads in engine operating conditions. Because of the crucial importance of its function, crankshaft fatigue life is desired to be higher than the predicted engine operating life. In this study, Puma I5 crankshaft dynamic simulation is performed with multi body dynamics technique. Fatigue safety factors are calculated with the dynamical loadings of engine operating conditions. The effects of single mass and dual mass flywheel on endurance limit are analyzed in this study.
Recommended Content
Authors
Citation
Duran, E. and Sever, A., "Dynamic Simulation and Endurance Limit Safety Factor Calculation for Crankshaft - Comparison of Single Mass and Dual Mass Flywheel," SAE Technical Paper 2008-01-2622, 2008, https://doi.org/10.4271/2008-01-2622.Also In
References
- Henry J. P. Toplosky J. Abramczuk M. Crankshaft Durability Prediction - A New 3-D Approach SAE Technical Paper Series, 920087
- Spiteri P. Ho S. Lee Y.L. Assesment of Bending Fatigue Limit for Crankshaft Sections with Inclusion of Residual Stresses International Journal of Fatigue 318 329 2007 Krishna M. M. R. Topology and Topography Optimization of a Drive Shaft SAE Technical Paper Series, 2005-01-3552
- Choi K. S. Pan J. Ho S. “Effects of Roller Geometry on Contact Pressure and Residual Stress in Crankshaft Fillet Rolling” SAE World Congress, SAE- 2005-01-1908
- Chien W. Y. Pan J. Close D. Ho S. Fatigue Analysis of Crankshaft Section Under Bending with Consideration of Residual Stresses International Journal of Fatigue 1 19 2005
- Williams J. Fatemi A. Fatigue Performance of Forged Steel and Ductile Cast Iron Crankshafts 2007 World Congress, SAE- 2007-01-1001
- AVL/Excite Power Unit User's Guide May 2007