This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
FEM and Experimental Analysis of Industrial Forming Processes
Technical Paper
2001-01-3218
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This paper deals with implementing process simulation in the developing of the manufacturing process for automobile panels and body parts. Starting from FEM analysis of material behaviour, suggestions about punch and die design can be obtained bringing direct and indirect benefits to other routing steps, thus saving time and resources. In order to point out these relationship and enhance these benefits, some real cases are presented and analysed for which a comparison among simulated and experimental results is given, using both circle grid and thickness analysis of the deformed blank sheet. Suggestions for part design modifications have been obtained that lead to a net improvement in formability and quality.
Citation
Basuc, D. and Lombardi, F., "FEM and Experimental Analysis of Industrial Forming Processes," SAE Technical Paper 2001-01-3218, 2001, https://doi.org/10.4271/2001-01-3218.Also In
References
- Arrieux R. “Determination and use of the forming limit stress diagrams in sheet metal forming” J. Mat. Proc. Tech 53 1995
- Buchar Z. “Circle grid analysis applied to the production problems of the car body panels” J. Mat. Proc. Tech 60 1996
- Col A. “Forming limit diagrams: a survey” International Conference on Technologies and Machine 2000
- “Formability of metallic materials” 1982
- Chen Fuh-Kuo Liu Jia-Hong “Analysis of die designs for the stamping of an automobile rear floor panel” J. Mat. Proc. Tech 55 1995
- Hosford W. F. Caddell R. M. “Metal Forming –mechanics and metallurgy” Prentice Hall Englewood Cliffs 1993
- Gronostajski J. Zimniak Z. “A few methods of analytical calculation of forming-limit curves” J. Mat. Proc. Tech 55 1995
- Kawka M. Olejenik L. Rosochowski A. Sunaga H. Makinouchi A. “Simulation of wrinkling in metal forming” J. Mat. Proc. Tech 109 2001
- 1978
- Makinouchi A. ”Sheet metal forming simulation in industry” J. Mat. Proc. Tech 60 1996
- Tisza M. “Simulation and knowledge based design in metal forming” International Conference on Technologies and Machine 2000
- Yang D.Y. Jung D.W. Song I.S. Yoo D.J. “Comparative investigation into implicit, explicit, and iterative implicit/explicit schemes for the simulation of sheet-metal forming processes” J. Mat. Proc. Tech 50 1995