J442_200811 Test Strip, Holder, and Gage for Shot Peening
Revised
11/24/2008
- Features
- Issuing Committee
- Content
- This SAE Standard defines requirements for equipment/supplies to be used in measuring shot peening intensity. Guidelines for the use of these articles (test strip, holding fixture, and gage) are also included.
- Content
- Section 6.4 – The flatness of the zero block should be changed to ±0.005 mm flatness from ±0.001 mm flatness because this degree of precision is not warranted for the measurement ranges required (0-0.610 mm range).Section 7.3 – Note added to indicate that all dimensions are in millimeters (mm) unless otherwise specified.
- Pages
- 7
- Citation
- SAE International Technical Standard, Test Strip, Holder, and Gage for Shot Peening, SAE Standard J442_200811, Revised November 2008, Issued January 1952, https://doi.org/10.4271/J442_200811.