J617_201404 Engine Flywheel Housing and Mating Transmission Housing Flanges
Revised
04/16/2014
- Features
- Issuing Committee
- Content
- This SAE Standard specifies the major dimensions and tolerances for Engine Flywheel Housings and the Mating Transmission Housing Flanges. It also locates the crankshaft flange face or the transmission pilot bore (or pilot bearing bore) stop face in relation to housing SAE flange face.This document is not intended to cover the design of the flywheel housing face mating with the engine crankcase rear face or the design of housing walls and ribs. Housing strength analysis and the selection of housing materials are also excluded.This document applies to any internal combustion engine which can utilize SAE No. 6 through SAE No. 00 size flywheel housing for mounting a transmission.
- Content
- Users of the document have identified an error in Table 1 for the OO housing pilot diameter nominal dimension. The inch dimension was correct but the millimeter dimension was wrong.
- Pages
- 8
- Citation
- SAE International Technical Standard, Engine Flywheel Housing and Mating Transmission Housing Flanges, SAE Standard J617_201404, Revised April 2014, Issued March 1916, https://doi.org/10.4271/J617_201404.