J617_202009 Engine Flywheel Housing and Mating Transmission Housing Flanges
Stabilized
09/29/2020
- Features
- Issuing Committee
- Content
- This SAE Standard specifies the major dimensions and tolerances for Engine Flywheel Housings and the Mating Transmission Housing Flanges. It also locates the crankshaft flange face or the transmission pilot bore (or pilot bearing bore) stop face in relation to housing SAE flange face.This document is not intended to cover the design of the flywheel housing face mating with the engine crankcase rear face or the design of housing walls and ribs. Housing strength analysis and the selection of housing materials are also excluded.This document applies to any internal combustion engine which can utilize SAE No. 6 through SAE No. 00 size flywheel housing for mounting a transmission.
- Content
- This technical report is being stabilized because it covers technology, products, or processes which are mature and not likely to change in the foreseeable future.
- Pages
- 9
- Citation
- SAE International Technical Standard, Engine Flywheel Housing and Mating Transmission Housing Flanges, SAE Standard J617_202009, Stabilized September 2020, Revised April 2014, Issued March 1916, https://doi.org/10.4271/J617_202009.