This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Emissions and Their Control in Natural Gas Fueled Engines
Annotation ability available
Sector:
Language:
English
Abstract
An experimental study was undertaken to investigate emissions of hydrocarbons, oxides of nitrogen, carbon monoxide, and methane hydrocarbons emitted by natural gas fueled engines and the extent of their conversion in catalysts. Two engines were used in the study: a four cylinder, 1.6 liter, spark ignition engine and a modified version of the same engine with only one of the cylinders operating at 0.4 liter capacity. Two-way and three-way catalysts were used to treat exhaust gases leaving the engine. Natural gas was supplied through gas carburetors operated at regulated pressures and supplying air-fuel ratios in the desired range.
The results of the investigation showed that oxides of nitrogen could not be reduced in a three-way catalyst to the levels found in gasoline fueled engines when the operating air-fuel ratio was stoichiometric. This was believed to be due to lower levels of carbon monoxide emitted by natural gas fueled engines at stoichiometric condition relative to a gasoline fueled engine at the same equivalence ratio. This was further confirmed by injecting small quantities of carbon monoxide in engine exhaust upstream of the converter. It was decided to operate the engines at slightly richer conditions to generate additional carbon monoxide in the exhaust. Measurements of chemical species before and after the converter showed substantial improvements in converter efficiency when the engines were operated at slightly richer air-fuel ratio and when the exhaust gas temperatures were over 750° K. Furthermore, methane conversion efficiencies in the three-way converter were in excess of 60% depending on exhaust gas temperatures. In the single cylinder engine tests lower exhaust gas temperatures yielded low methane conversion efficiencies than in the four cylinder engine case.
Recommended Content
Authors
Topic
Citation
Varde, K., Cherng, J., Bailey, C., and Majewski, W., "Emissions and Their Control in Natural Gas Fueled Engines," SAE Technical Paper 922250, 1992, https://doi.org/10.4271/922250.Also In
References
- Lovell, W.G. “Engine Knock and Molecular Structure of Hydrocarbons” SAE Trans. (Q) 2 532 1948
- King, R.O. Wallace, W.A. Mahapatra, B. “The Oxidation, Ignition, and Detonation of Fuel Vapors and Gases” Can. J. Research (F) 26 264 1948
- Karim, G.A. Klat S.R. “The Knock and Autoignition Characteristics of some Gaseous Fuels and their Mixtures” J. Inst. of Fuel 39 109 119 1966
- Kuivaneu, G.J. Westra, R.O. Lien, D.G. “Engine Fuel Relationships with LPG and Natural Gas” SAE Paper No. 670053
- Karim, G.A. Ali, A.I. “Combustion, Knock and Emission Characteristics of a Natural Gas Fueled SI engine with Particular Reference to Low Intake Temperature Conditions” Proc. Inst Mech Engrs 189 24 1975
- Seal, M.R. Leatham, M. Jackson, P.S. “Propane/Methane Development Program” SAE Paper No. 831198 1983
- Liss, W.E. Thrasher, W.H. “Natural Gas as a Stationary Engine and Vehicular Fuel” SAE Paper 912364 1991
- Singh, M.K. “A Comparative Analysis of Alternative Fuel Infrastructure Requirements” SAE Paper 892065 1989
- Karim, G.A. Wierzba, I “Comparative Studies of Methane and Propane as Fuels for SI and Compression Ignition Engines” SAE Paper No. 831196 1983
- Born, G.J. Durbin, E.J. “The Natural Gas Fueled Engine in Methane Fuel for the Future” McGeer Durbin 101 113 Plenum Press New York 1982
- Ko, Y. Kurihara, K. Sakai, T. Osuga, R. Choi, B. Ayusawa, T. “Research and Development of LNG Vehicle for Practical Use” SAE Paper No. 920594 1992
- Weaver, C.S. “Natural Gas Vehicle - A Review of the State of the Art” SAE Paper No. 892133 1989
- Klimstra, J. “Catalytic Converters for Natural Gas Fueled Engines - A Measurement and Control Problem” SAE Paper No. 872165 1987
- Nylund, N. Riikonen, A. “Low Polluting Gas Fueled Heavy Duly Vehicles” SAE Paper No. 912365 1991
- Burns, K.R. Collins, M.F. Heck, R.M. “Catalytic Control of NO x Emissions from Stationary Rich - Burning Natural Gas Engines” ASME Paper 83 - DPG - 12 1983
- Klimstra, J. “Performance of Lean-Burn Natural-Gas-Fueled Engines On Specific Fuel Consumption, Power Capacity, and Emissions” SAE Paper No. 901495 1990
- Sakai, T. Choi, B. Osuga, R. Ko, Y. Kim, E. “Unburned Fuel and Formaldehyde Purification Characteristics of Catalytic Converters for Natural Gas Fueled Automotive Engine” SAE Paper 920596 1992
- Engman, T.J. “Stationary, Gaseous - Fueled, I.C. Engine Air-Fuel Ratio Control for Application of Three-Way Catalyst for Exhaust Emission Reduction” ASME Paper 83 - DPG - 3 1983
- Golomb, D. Fay, J.A. “The Role of Methane in Tropospheric Chemistry” A report of the Energy Laboratories Cambridge, MA 1989
- Raine, R.R. Jones, G.M. “Comparison of Temperatures Measured in Natural Gas and Gasoline Fueled Engines” SAE Paper 901503 1990
- Blumberg, P. Kummer, J.K. “Prediction of NO Formation in Spark-Ignition Engines - An Analysis of Methods of Control” Combust. Sci. Technol. 4 73 96 1971
- Lavoie, G.A. Heywood, J.B. Keck, J.C. “Experimental and Theoretical Investigation of NO Formation in Internal Combustion Engines” Combust. Sci. Technol. 1 313 326 1970
- Lucas, G.G. Varde, K.S. “Analysis of Nitric Oxide Formation in Spark-Ignition Engine with Heat Transfer and Effect of Ignition Point” SAE Paper 740189 1974
- White, J.J. “Low Emission Catalysts for Natural Gas Engines” A Report presented to GRI Engine Technical Advisory Committee 1991
- Rudy, W.M. “Catalytic Control of Exhaust Emissions from CNG Fueled Engines” Technical Report presented at the SAE Optimized Methanol and Natural Gas Fueled Vehicles Workshop Knoxville, TN September 1990
- Yakabe, H. Tai, H. Matsuura, M. “Air-to-Fuel Ratio Control of Gas Engines Using Response Characteristics of Three-Way Catalysts under Dynamic Operation” SAE Paper 912362 1991