This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Effectiveness of Methods of Power Distribution in Transmissions of All-Wheel-Drive Trucks
Technical Paper
2015-01-2732
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The main indicators for mobility of a multipurpose wheeled vehicle are the maximum and average technical velocity, and they are mainly determined by power-to-weight ratio and the parameters of the suspension. As our analysis shows, with the increase of the power-to-weight ratio of the vehicle and its weight, the growth rate of the velocity is reduced, and after reaching a certain value, the velocity remains almost constant. This is due to the fact that for operating conditions of the multi-purpose wheeled vehicle, movement on roads with different degrees of uneven distribution of the rolling resistance and adhesion, in both transverse and longitudinal directions, is typical.
In this investigation we evaluate the effectiveness of the main methods of power distribution among drive wheels of the multi-purpose wheeled vehicles. It was revealed that the transmission of a promising multipurpose wheeled vehicle has to be modernized in the following ways: 1) all-wheel drive with the rational value of the gear ratio of inter-axle differential; 2) realization of the possibility of periodic shutdown of the drive axles when road conditions are good, or turning on the additional driving axles of the trailer when the road conditions require significant drive forces and torques; 3) providing of limited excess capacity of power unit by reducing the fuel supply or applying braking torque to the slipping wheels; 4) providing of rigid kinematic connection in the movement process with compensation of the kinematic mismatch by adjusting of air pressure in the tires.
At present, the effectiveness of the proposed methods of power distribution has been investigated in different extent. Thus, there arises the problem of the complex evaluation of the effectiveness of methods of the power distribution between the drive wheels of the multi-purpose wheeled vehicle. This investigation is devoted to this problem.
Topic
Citation
Keller, A. and Aliukov, S., "Effectiveness of Methods of Power Distribution in Transmissions of All-Wheel-Drive Trucks," SAE Technical Paper 2015-01-2732, 2015, https://doi.org/10.4271/2015-01-2732.Also In
References
- Keller A. , and Murog I. Principles and methods of distribution of power among drive wheels of automobile chassis base Chelyabinsk 2009
- Pliev I. Multi-purpose vehicles Moscow Moscow State Industrial University 2011
- Verzhbitzkij A. , and Pliev I. Analysis of parameters and designs of domestic and foreign vehicles Cars and motors Moscow NAMI 231 2003
- Kaminaga et al. Vehicle Body Slip Angle Estimation Using an Adaptive Observer Proceeding of JSAE (Society of Automotive Engineers of Japan) 9832693 1998
- Hu X. et al. Energy efficiency analysis of a series plug-in hybrid electric bus with different energy management strategies and battery sizes Applied Energy 111 2013 1001 1009
- Keller A. , Murog I. et al. Comprehensive assessment of the effectiveness of methods of power distribution in mechanical transmissions Automotive industry 4 2013
- Fukumura et al. The method of optimizing Traction Control System (TCS) and an application to vehicle dynamics control system Proceeding of JSAE (Society of Automotive Engineers of Japan) 9636961 1996
- Kageyama et al. A Study of Anti-Lock Braking Systems with Estimation AVEC 1996
- Gillespie , T. Fundamentals of Vehicle Dynamics Warrendale SAE International 1992 10.4271/R-114
- Hoeck , M. and Gasch , C. The Influence of Various 4WD Driveline Configurations on Handling and Traction on Low Friction Surfaces SAE Technical Paper 1999-01-0743 1999 10.4271/1999-01-0743
- Keller , A. , Murog , I. , and Aliukov , S. Comparative Analysis of Methods of Power Distribution in Mechanical Transmissions and Evaluation of their Effectiveness SAE Technical Paper 2015-01-1097 2015 10.4271/2015-01-1097
- Aliukov , S. , Keller , A. , and Alyukov , A. Dynamics of Overrunning Clutches of Relay Type SAE Technical Paper 2015-01-1130 2015 10.4271/2015-01-1130
- Keller , A. , and Aliukov , S. Analysis of Possible Ways of Power Distribution in an All-wheel Drive Vehicle Lecture Notes in Engineering and Computer Science: Proceedings of The World Congress on Engineering 2015 1 3 July 2015 London, U.K. 1154 1158
- Keller , A. , and Aliukov , S. Efficient Power Distribution in an All-wheel Drive Truck Lecture Notes in Engineering and Computer Science: Proceedings of The World Congress on Engineering 2015 1 3 July 2015 London, U.K. 1201 1206
- Aliukov , S. , and Keller , A. On the Question of Mathematical Model of an Overrunning Clutch Lecture Notes in Engineering and Computer Science: Proceedings of The World Congress on Engineering 2015 1 3 July 2015 London, U.K. 1319 1324