This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Heat Rejection and Skin Temperatures of an Externally Cooled Exhaust Manifold
Technical Paper
2015-01-1736
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The heat rejection rates and skin temperatures of a liquid cooled exhaust manifold on a 3.5 L Gasoline Turbocharged Direct Injection (GTDI) engine are determined experimentally using an external cooling circuit, which is capable of controlling the manifold coolant inlet temperature, outlet pressure, and flow rate. The manifold is equipped with a jacket that surrounds the collector region and is cooled with an aqueous solution of ethylene-glycol-based antifreeze to reduce skin temperatures. Results were obtained by sweeping the manifold coolant flow rate from 2.0 to 0.2 gpm at 12 different engine operating points of increasing brake power up to 220 hp. The nominal coolant inlet temperature and outlet pressure were 85 °C and 13 psig, respectively. Data were collected under steady conditions and time averaged. For the majority of operating conditions, the manifold heat rejection rate is shown to be relatively insensitive to changes in manifold coolant flow rate. The manifold cooling jacket is observed to successfully reduce skin temperatures in the collector region. However, away from the cooling jacket, skin temperatures are insensitive to changes in manifold coolant flow rate, but remain below the iron-carbon lower transformation temperature limit near 750 °C.
Recommended Content
Authors
Citation
Cartwright, J., Selamet, A., Wade, R., Miazgowicz, K. et al., "Heat Rejection and Skin Temperatures of an Externally Cooled Exhaust Manifold," SAE Technical Paper 2015-01-1736, 2015, https://doi.org/10.4271/2015-01-1736.Also In
References
- Pawlowski , B. Critical points of hypoeutectoid steel - prediction of the pearlite dissolution finish temperature Ac1f Journal of Achievements in Materials and Manufacturing Engineering 49 2 331 337 2011
- Li , D. , Perrin , R. , Burger , G. , McFarlan , D. et al. Solidification Behavior, Microstructure, Mechanical Properties, Hot Oxidation and Thermal Fatigue Resistance of High Silicon SiMo Nodular Cast Irons SAE Technical Paper 2004-01-0792 2004 10.4271/2004-01-0792
- Cartwright , J. The Characterization of an Externally Cooled Exhaust Manifold M.S. thesis Department of Mechanical Engineering, The Ohio State University Columbus 2013
- Heywood , J.B. Internal Combustion Engine Fudamentals McGraw-Hill New York 0-07-028637-X 1988
- Malchow , G. , Sorenson , S. , and Buckius , R. Heat Transfer in the Straight Section of an Exhaust Port of a Spark Ignition Engine SAE Technical Paper 790309 1979 10.4271/790309