This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Evaluation of J Factor and Leakage Quality for High Pressure Die Casting Applied to Closed-deck Type Cylinder Block
Technical Paper
2011-32-0504
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The relationship of J factor and internal casting quality in high pressure die casting was investigated by leakage testing conducted after the machining process. The trial die, used for motorcycle engine applications, was a single closed-deck-type liner-less cylinder block with an expendable salt core. The J factor was calculated by using the VanRens equation with varied gate thickness, gate speed, plunger diameter, and casting pressure. To confirm casting quality by leakage testing, we conducted X-ray computerized tomography (XRC), micro-focus XRC, and thermal decomposition gas chromatographic determination analysis. In addition, XRC was used to calculate the total shrinkage volume. A strong correlation was found between the J factor and tightness against pressure leakage.
Recommended Content
Authors
Citation
Yamada, Y., Yoshii, H., Mochizuki, S., Bannai, Y. et al., "Evaluation of J Factor and Leakage Quality for High Pressure Die Casting Applied to Closed-deck Type Cylinder Block," SAE Technical Paper 2011-32-0504, 2011, https://doi.org/10.4271/2011-32-0504.Also In
References
- Yaokawa, J. et al. CALPHAD 31 2007 155 163
- Yaokawa, J. et al. Mater. Trans 48 2007 1034 1041
- Yaokawa, J. et al. J.JFS 78 2006 516 522
- Yaokawa, J. et al. J.JFS 79 2007 184 191
- Oikawa, K. et al. J.JFS 81 2009 232 237
- Yamada, Y. Yaokawa, J. et al. SETC 2007 JSAE, 20076584 SAE 2007-32-0084
- Bennett, F. C. The Soc. Die Cast. Engr. Nov. 1966
- Van Rens, R. North Am. Die Cast. Asso. 1996
- Herman, E. A. Gating NADCA pub.E-514 1996
- Ward, M. Gating Manual NADCA pub.#512
- Wronowicz, J. PQ 2 NADCA pub. 2006
- Kaneuchi, T. Tech. Rep. Hitachi Met. 23 27 32 2007
- Kaneuchi, T. Japan Foundryman Soc. Rep. No.100 “Die Casting Process Tech.” 23 28 2006
- Kaneuchi, T. 2004 Japan Die Casting Congress, JD04-06 277 282 2004
- Gouda, Y. Yaokawa, J. Rep. J.JFS., 148 th Conf. 2006
- Herman, E. A. NADCA Tech. Pa.No.54 Nov. 1968
- Hitachi metal “Special steel General catalogue” HYA1-Q 230 2002 2