This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Brake Squeal Analysis by Finite Elements
Technical Paper
1999-01-1736
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
An approximate analysis method for brake squeal is presented. Using MSC/NASTRAN a geometric nonlinear solution is run using a friction stiffness matrix to model the contact between the pad and rotor. The friction coefficient can be pressure dependent. Next, linearized complex modes are found where the interface is set in a slip condition. Since the entire interface is set sliding, it produces the maximum friction work possible during the vibration. It is a conservative measure for stability evaluation. An averaged friction coefficient is measured and used during squeal. Dynamically unstable modes are found during squeal. They are due to friction coupling of neighboring modes. When these modes are decoupled, they are stabilized and squeal is eliminated. Good correlation with experimental results is shown. It will be shown that the complex modes baseline solution is insensitive to the type of variations in pressure and velocity that occur in a test schedule. This is due to the conservative nature of the approximation. Convective mass effects have not been included.
Recommended Content
Technical Paper | A Study on the Reduction of Disc Brake Squeal Using Complex Eigenvalue Analysis |
Technical Paper | Brake Squeal DOE Using Nonlinear Transient Analysis |
Technical Paper | The Integrated Test Concept: Dyno - Vehicle, Performance - Noise |
Authors
Topic
Citation
Nack, W., "Brake Squeal Analysis by Finite Elements," SAE Technical Paper 1999-01-1736, 1999, https://doi.org/10.4271/1999-01-1736.Also In
References
- Nack, W.V. Joshi, A.M. “Friction Induced Vibration: Brake Moan SAE paper 951095 1995
- Tworzydlo, W.W. Oden, J.T. et al “Numerical Modeling of Friction Induced Vibrations and Dynamic Instability ASME DE 49 1992
- Liles, G.D. “Analysis of Brake Squeal Using Finite Element Methods” SAE paper 891150 1989
- Dowell, E.H. A Modern Course in Aeroelasticity Kluwer 1995
- Machowski, J. Power System Dynamics and Stability Wiley 1997
- Thompson, J.M.T. Instabilities and Catastrophes in Science and Engineering Wiley 1982
- Thompson, J.M.T. et al Nonlinear Dynamics and Chaos: Geometrical Methods for Engineers and Scientist Wiley 1986
- Seydel, R. Practical Bifurcation and Stability Analysis: From Equilibrium to Chaos Springer 1994
- Nayfeh, A.H. et al Applied Nonlinear Dynamics: Analytical, Computational and Experimental Wiley 1995
- Troger, H. Steindl, A. Nonlinear Stability and Bifurcation Theory: An Introduction for Engineers and Applied Scientists Springer 1991
- Marion, J.B. Thornton, S.T. Classical Dynamics of Particles and Systems 3rd Harcourt, Brace, Jovanovitch 1988
- Nayfeh, A.H. Mook, D.T. Nonlinear Oscillations Wiley 1979
- Tworzydlo, W.W. et al. “Experimental and Numerical Studies of Friction Induced Oscillations of a Pin on Disk Apparatus” 1997
- Matsushima, T. Masumo, H. Ito, S. Nishiwaki, M. “FE Analysis of Low Frequency Disk Brake Squeal” SAE paper 982251 1998
- Dihua, G. Dongying, J. “A Study on Disk Brake Squeal Using Finite Element Methods” SAE paper 980597 1998
- Hu, Y.K. et al “Brake Noise DOE Using Non-Linear Transient Analysis” SAE Noise & Vibration Conference May 1999
- Szemplinska - Stupnicka, W. The Behavior of Nonlinear Vibrating Systems II Kluwer 1990