Your Selections

Michigan Tech APS LABS
Show Only

Collections

File Formats

Content Types

Dates

Sectors

Topics

Authors

Publishers

Affiliations

Events

   This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Methods of Pegging Cylinder Pressure to Maximize Data Quality

Michigan Tech APS LABS-Jeremy Worm
Michigan Technological Univ-Darrell Robinette
Published 2019-04-02 by SAE International in United States
Engine cylinder pressure is traditionally measured with a piezo-electric pressure transducer, and as such, must be referenced or pegged to a known value. Frequently, the cylinder pressure is pegged to the pressure in the intake manifold plenum whereby the manifold absolute pressure (MAP) at the end of the intake stroke is measured and the cylinder pressure trace for the entire cycle is adjusted such that the cylinder pressure is set equal to the manifold pressure at the end of the intake stroke. However, any error in pegging induces an error in the cylinder pressure trace, which has an adverse effect on the entire combustion analysis. This research is focused on assessing the pegging error for several pegging methods across a wide range of engine operating conditions, and ultimately determining best practices to minimize error in pegging and the calculated combustion metrics. The study was conducted through 1D simulations using the commercially available GT-Power. The test matrix included variations of speed, load, intake runner length and intake valve timing. Five different pegging locations were compared, and…
This content contains downloadable datasets
Annotation ability available