An Analysis of EDR Data in Kawasaki Ninja 300 (EX300) Motorcycles
2017-01-1436
03/28/2017
- Features
- Event
- Content
- Various electronic control units from Kawasaki Ninja 300 motorcycles were tested in-situ in order to heuristically examine the capabilities and behavior of the event data recorders (EDR). The relevant hexadecimal data was downloaded from the ECU and translated using known and historically proven applications. The hexadecimal translations were then confirmed using data acquisition systems as well as the Kawasaki Diagnostic Software (KDS). Numerous tests were performed to establish the algorithms which cause the EDR to record data. It was determined that the EDR recording “trigger” was caused by the activation of the tip-over sensor, which in turn shuts the engine off. In addition, specific conditions must be met with regards to the rear wheel rotation prior to engine shut-down. An EDR event was only recorded if the motorcycle was commanded to shut-down by the tip-over sensor, and either had rear wheel movement at the time of shut-down or the rear wheel experienced a sudden deceleration in the several seconds prior to shut-down. The “time zero” data element was synchronous with the tip-over commanded shut-down signal. Various data elements were stored at either 10 Hz or 2 Hz for a total of 8 seconds of data prior to the commanded engine shut-down. Each data element was analyzed as to how it was recorded and displayed in the various data tables. Additionally, issues of sensor and power loss were analyzed and discussed.
- Pages
- 12
- Citation
- Fatzinger, E., and Landerville, J., "An Analysis of EDR Data in Kawasaki Ninja 300 (EX300) Motorcycles," SAE Technical Paper 2017-01-1436, 2017, https://doi.org/10.4271/2017-01-1436.