This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Specification for Testing Automotive Light Bulb Sockets
- Ground Vehicle Standard
- USCAR15-2
- Issued
Sector:
Issuing Committee:
Language:
English
Scope
This specification establishes the requirements and test procedures for automotive miniature bulb retention devices, including wedge base sockets with integral connector, direct wire wedge base sockets, circuit plate assemblies, and associated interfaces.
Tests shall follow the sequence shown in the flow charts in Appendix E whenever the following occurs:
-
New design
-
Design, material or process change made to an existing device, which could affect the outcome of the test.
The test sequence shown in Appendix F shall be run annually.
(Note: Production process control data collected at a shorter interval per an approved control plan, may be substituted if approved by customer’s responsible engineer and purchasing representative.)
Recommended Content
Ground Vehicle Standard | Specification For Testing Automotive Miniature Bulb Socket/Circuit Plate Assemblies |
Ground Vehicle Standard | ELECTRICAL CONNECTOR ASSEMBLY ERGONOMIC DESIGN CRITERIA |
Ground Vehicle Standard | Headlamp Cleaners |
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Reference
Number | Title |
---|
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.