This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Tolerances, Metric Rubber Products
- Aerospace Material Specification
Published August 01, 1998 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers established metric (SI) manufacturing tolerances applicable to non-cellular rubber products ordered to metric dimensions. These tolerances apply to all conditions, unless otherwise noted. The term "exclusive" applies only to the higher figure of the specified range.
|Aerospace Material Specification||Silicone Rubber Sponge Closed Cell, Medium|
|Aerospace Material Specification||Sponge, Chloroprene (CR) Rubber Soft|
|Aerospace Material Specification||Sponge, Chloroprene (CR) Rubber Medium Stiffness|
Data Sets - Support Documents
|TABLE 1||Thickness Tolerances|
|TABLE 2||Width Tolerances|
|TABLE 6||Length Tolerances|
|TABLE 7||Length Tolerances|
Welcome to the AMS-CE Elastomers Committee Discussion Forum.The AMS-CE Elastomers Committee maintains Aerospace Materials Specifications (AMS), Aerospace Recommended Practices (ARP), Aerospace Information Reports (AIR) and Aerospace Standards (AS) on elastomeric materials. AMS-CE, which reports to the Aerospace Materials Division, coordinates and maintains liaison with industry, government and other standardization groups on elastomeric materials. A significant part of this committee is concerned with elastomeric fluid sealing materials, their applications, material development, testing, quality, design parameters and design practices. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.