This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
SPECIFICATIONS AND METHODS OF TEST FOR RUBBER BOOTS FOR USE ON DRUM TYPE HYDRAULIC BRAKE WHEEL CYLINDERS
- Ground Vehicle Standard
- J65A_197101
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
These specifications cover molded rubber boots used as end closures on drum type wheel brake actuating cylinders to prevent the entrance of dirt and moisture which could cause corrosion and otherwise impair wheel brake operation.
The specifications include performance tests of brake cylinder boots of both plain and metal insert types under specified conditions and do not include requirements relating to chemical composition, tensile strength, or elongation of the rubber compound. Further, they do not cover the strength of the adhesion of rubber to metal in the insert type.
The rubber material used in these boots is classified as suitable for operation in a temperature range of −40 to +120 ±2 C (−40 to +248 ±3.6 F).
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Reference
Number | Title |
---|
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.