This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Welded and Cold-Drawn, High Strength (690 MPa Tensile Strength) Low Alloy Steel Hydraulic Tubing, Stress Relieved Annealed for Bending and Flaring
- Ground Vehicle Standard
Published August 18, 2009 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers sub-critically annealed electric resistance welded and cold-drawn single-wall high strength low alloy steel tubing intended for use in hydraulic pressure lines and in other applications requiring tubing of a quality suitable for bending, flaring, cold forming, welding and brazing.
The grade of material produced to this specification is of micro-alloy content and is considerably stronger and intended to service higher pressure applications using thinner walls than like sizes of the grades of material specified in SAE J525, SAE J2467 and SAE J2614. Due to the alloy content of the material, the forming characteristics of the finished tube are equal to or better, when compared to SAE J525, SAE J2467 and SAE J2614. Nominal reference working pressures for this tubing are listed in ISO 10763 and SAE J1065.
Caution: When brazing or welding is used as a tube end joining method, the structural integrity of the tube material can potentially be compromised due to the degradation of the areas affected by the thermal effect applied to the tubing; therefore, the ISO 10763 and SAE J1065 nominal reference working pressures may not be applicable.
Brazed and/or welded tube assembly configurations made to specific geometry and components bill of material in association with this material, may require qualification testing in accordance with ISO 19879 Test Methods for Hydraulic Fluid Power Connections. Cold forming the tube end configurations avoids this systemic testing by not compromising the tube material structural integrity.
The working pressures of the modern day mobile equipment hydraulic systems have risen dramatically as compared to the hydraulic pressures in the past. This new hydraulic tubing material has been developed to fill the needs of the hydraulic industry by providing a tube material matched with modern day high pressure hydraulic hose and connectors to help resolve the hydraulic system space constraints and routing issues faced by today’s system designers in the hydraulic mobile equipment industry. Aircraft and Aerospace applications were not considered during the preparation of this document.
Data Sets - Support Documents
|Unnamed Dataset 1|
|Unnamed Dataset 2|
|Unnamed Dataset 3|
|Unnamed Dataset 4|
|Unnamed Dataset 5|
|TABLE 1||TUBING OUTSIDE DIAMETER TOLERANCE|
|TABLE 2||TUBING WALL THICKNESS TOLERANCES|
|TABLE 3||CHEMICAL REQUIREMENTS|
|TABLE 4||MECHANICAL PROPERTIES|
The Metallic Tubing Subcommittee of the FCCTC develops and maintains SAE Standards, Recommended Practices and Information Reports relating to metallic tubing with an intended use in pressure applications. Participants in the FCCTC Metallic Tubing Subcommittee include OEMs, suppliers, consulting firms, government and other interested parties.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.