This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Inboard Mounted Disc Brake Rotor/Disc Wheel Hub Interface Dimensions - Commercial Vehicles
- Ground Vehicle Standard
Published May 29, 2012 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This SAE Recommended Practice establishes dimensions and tolerances for the interface between inboard mounted disc brake rotors and disc wheel hubs. The geometric features described in this document are shown at true position. This document is intended for inboard mounted disc brake rotors and disc wheel hubs for Class 5, 6, 7, and 8 commercial vehicles. Special and less common applications are not covered.
This document was developed to help the commercial vehicle market standardize the hub and rotor interface dimensions for class 5, 6, 7, and 8 vehicles equipped with disc brakes.
|Technical Paper||Development of a Lightweight Small Car Disc Brake System for International Usage|
|Technical Paper||A METHOD FOR MESUARING CREEP GROAN BASED ON BRAKE INERTIAL DINAMOMETER|
Data Sets - Support Documents
|Unnamed Dataset 1|
|TABLE 1||U-SECTION BRAKE ROTOR DIMENSIONS|
|TABLE 2||DISC BRAKE HUB DIMENSIONS FOR USE WITH U-SECTION ROTORS|
|TABLE 3||HAT SECTION BRAKE ROTOR DIMENSIONS|
|TABLE 4||DISC BRAKE HUB DIMENSIONS FOR USE WITH HAT SECTION ROTORS|
The responsibility of the Truck and Bus Wheel Committee of the Truck and Bus Brake and Advanced Driver Assistance Systems Steering Committee is to initiate, develop, review and approve the recommended practices, standards, and information reports related to hubs, wheels and the wheel mounting systems of buses, trucks and tractor-trailer combinations intended for highway use. The Wheel Committee is constituted so as to be aware of other SAE wheel activity and to prevent duplication of effort.
|J1671_201502||Outboard Mounted Brake Drum/Disc Wheel Hub Interface Dimensions - Truck and Bus|
|J393_201710||Nomenclature - Wheels, Hubs, and Rims for Commercial Vehicles|
|J694_201505||Disc Wheel and Hub or Drum Interface Dimensions - Truck and Bus|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.