This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Electric Windshield Washer Switch - Trucks, Buses, and Multipurpose Vehicles
- Ground Vehicle Standard
Published December 19, 2012 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This SAE Recommended Practice establishes for trucks, buses, and multipurpose passenger vehicles with GVW of 4500 kg (10 000 lb) or greater:
Minimum performance requirements for the switch for activating electric or electro-pneumatic windshield washer systems.
Uniform test procedures that include those tests that can be conducted on uniform test equipment by commercially available laboratory facilities.
The test procedures and minimum performance requirements, outlined in this document, are based on currently available engineering data.
It is the intent that all portions of the document will be periodically reviewed and revised as additional data regarding windshield washing system performance is developed.
The typo is an obvious error since a temperature cannot be 165 degrees C and 74 degrees C at the same time. The conversion was correct but the annotation should have been F rather than C.
|Ground Vehicle Standard||FLASHERS|
|Ground Vehicle Standard||BACKUP LAMP SWITCH|
Data Sets - Support Documents
|Unnamed Dataset 1|
Truck and Bus Windshield Wipers and Climate Control Comm
The responsibility of Windshield Wipers and Climate Control Committee of the Truck and Bus Body, Occupant and Environment Steering Committee is to initiate, develop, review and approve the recommended practices, standards, and information reports related to windshield washer/wiper systems, defroster/defogging systems and components that affect the interior climate and environment of occupied areas of trucks, buses and multi purpose vehicles intended for on-highway use.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.