This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Ship Systems and Equipment - Part Standard for Studs - Continuous and Double End (Metric)
- Ground Vehicle Standard
- J2271M_201508
- Stabilized
Downloadable datasets available
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Parts Standard provides dimensional and quality assurance requirements for M6 through M36 metric sizes of studs in the following configurations in materials needed for ship system applications:
-
a
Continuous thread studs in M thread profile.
-
b
Double end studs—clamping type (also called bolt-studs) where both ends are of the same thread series but different lengths (M thread profile).
Rationale
SAE J2271M differs from the more recently developed American National Standard ASME B18.31.1M – Metric Continuous and Double End Metric Studs. In most cases there are studs covered by ASME B18.31.1M that are more readily available and can be interchangeably substituted for the J2271M studs. In addition, the references to SAE J121 and J123 in J2271M have been superseded by ASTM specifications and ASTM F568M has been cancelled without replacement although ISO 898-1 covers similar materials. ASME B18.18.3M referenced in J2271had been superseded by ASME B18.18 and Category 2 is applicable unless another category is specified by the purchaser.
It is recommended that ASME B18.31.1M be used for new design. However, it is considered important that the J2271M standard be available for reference to support those applications where it has been used. The Part Identification Numbers (PINs) in J2271M may have been used on drawings and users may need to refer to this part standard to identify the characteristics of the studs.
Recommended Content
Topic
Data Sets - Support Documents
Title | Description | Download |
---|---|---|
TABLE 1 | COMBINATIONS OF STUD TYPES AND BODY DIAMETERS | |
TABLE 2 | BODY DIMENSIONS FOR DOUBLE ENDED STUDS | |
TABLE 3 | TOLERANCE ON STUD LENGTH | |
TABLE 4 | MATERIALS |
Issuing Committee
Reference
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.