Road Vehicles - High Pressure Fuel Injection Pipe End - Connections With 60 Degree Female Cone
- Ground Vehicle Standard
- J1949_201511
- Cancelled
Scope
This SAE Standard specifies the dimensional requirements for the assembly of high-pressure pipe connections for compression-ignition (diesel) engine fuel injection equipment.
It applies to 60 deg female cones with external threaded connectors types 1 and 2, and to the internal threaded tube nuts and male cone type end assembly of high- pressure pipe connections for tubes with diameters up to 12 mm inclusive.
Rationale
Recommended Content
| Aerospace Material Specification | Aluminum Alloy, Bars, Rolled Or Cold Finished 1.0mg 0.60si 0.28cu 0.20cr Stress Relief Stretched |
| Aerospace Material Specification | Manganese Alloy, Brazing Filler Metal 66Mn - 16Ni - 16Co - 0.80B 1770 to 1875 °F (966 to 1024 °C) Solidus-Liquidus Range |
Data Sets - Support Documents
Issuing Committee
Diesel Fuel Injection Equipment Standards Committee
The Diesel Fuel Injection Equipment Standards Committee reports to the Powertrain Systems Group of the Motor Vehicle Council. The Committee is responsible for developing and maintaining SAE Standards, Recommended Practices, and Information Reports related to the design, manufacture, use and servicing of diesel fuel injection equipment. These documents are developed in harmony with the International Organization for Standardization (ISO). The committee serves as the U.S. delegate to ISO/TC22/SC7 - Road Vehicles, Injection Equipment and Filters. Participants in the SAE Diesel Fuel Injection Equipment Standards Committee include OEMs, suppliers, consulting firms, government, and other interested parties.
Reference
| Number | Title |
|---|---|
| ISO261 | This document is not part of the subscrption. |
| ISO3508 | This document is not part of the subscrption. |