Application Layer - Diagnostics
- Ground Vehicle Standard
The SAE J1939 series of recommended practices are intended for light- and heavy-duty vehicle uses on- or off-road as well as appropriate stationary applications which use vehicle derived components (e.g., generator sets). Vehicles of interest include, but are not limited to: on- and off-highway trucks and their trailers, construction equipment, and agriculture equipment and implements.
The purpose of these documents is to provide an open interconnect system for on-board electronic systems. It is the intention of these documents to allow electronic devices to communicate with each other by providing a standard architecture.
J1939-73 identifies the diagnostic connector to be used for the vehicle service tool interface and defines messages to accoumplish diagnostic services. California-regulated OBD II requirements are satisfied with a subset of the specified connector and the defined messages. Diagnostic messages (DMs) provide the utility needed when the vehicle is being repaired. Diagnostic meassages are also used during vehicle operation by the netwroked electronic control modules to allow them to report diagnostic information and self-compensate as appropriate, based on information received. Diagnostic messages include services such as periodically broadcasting active diagnostic trouble codes, identifiying operator diagnostic lamp status, reading or clearing diagnostic trouble codes, reading or writing control module memory, provide a security function, stopping/starting message broadcasts, reporting diagnostic readiness, monitoring engine parametric data, etc.
|Journal Article||Vehicle Level Approach for Optimization of On-Board Diagnostic Strategies for Fault Management|
|Technical Paper||Software Services in Automotive Class A and B Multiplex Applications|
|Ground Vehicle Standard||Vehicle Application Layer|
Data Sets - Support Documents
The Truck and Bus Control and Communications Network Committee of the Truck & Bus Electrical/Electronic Steering Committee is responsible for developing, reviewing and approving standards, recommended practices and information reports related to communication networks for the exchange of control and diagnostic information among electronic components on or connected to truck and bus vehicles. The objective is the architecture of communication networks offering an open interconnect system that supports communication between loose package components, such as engines and transmissions, which are sourced from many different component suppliers and integrated into vehicle systems. The communication networks are developed for use in on-highway and off-highway trucks and their trailers, buses, construction equipment, and agricultural equipment and implements, and applicable to light-duty, medium-duty, and heavy-duty vehicles used on-road or off-road, and for appropriate stationary applications which use vehicle derived components (e.g. generator sets).
|J1587||This document is not part of the subscrption.|
|J1587_201301||Electronic Data Interchange Between Microcomputer Systems in Heavy-Duty Vehicle Applications|
|J1939/03_202105||On-Board Diagnostics Implementation Guide|
|J1939/13_201110||Off-Board Diagnostic Connector|
|J1939/21_201012||Data Link Layer|
|J1939/21_201504||Data Link Layer|
|J1939/71_201103||Vehicle Application Layer (Through May 2010)|
|J1939/71_201309||Vehicle Application Layer|
|J1939_201104||Serial Control and Communications Heavy Duty Vehicle Network - Top Level Document|
|J1939_201308||Serial Control and Communications Heavy Duty Vehicle Network - Top Level Document|
|J1979_201202||E/E Diagnostic Test Modes|
|J1979_201408||E/E Diagnostic Test Modes|