This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Hose Assemblies, Rubber, Hydraulic, Steel Wire Reinforced--Part 1: Procurement Document
- Ground Vehicle Standard
- J1754/1_200710
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Standard covers steel wire reinforced rubber hose assemblies using connectors specified in SAE J516 for use in hydraulic systems using petroleum based hydraulic fluids with maximum working pressures of 1.7 to 42 MPa. See SAE J1754-2, Table 8 for hose operating temperature ranges and identification codes.
Note: Working pressure is defined as maximum system pressure.
Rationale
Presently SAE Standards J1754-1 and SAE J1754-2 contain the procurement requirements and ordering
information for 21MPa maximum working pressure, hydraulic, rubber hose assemblies with 37° flare fittings. It
has been suggested that these standards be re-written to include the most common pressures and fitting end
configurations used in the industry.
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Hydraulic Hose and Hose Fittings Committee
The Hydraulic Hose and Hose Fittings Subcommittee of the FCCTC develops and maintains SAE Standards, Recommended Practices and Information Reports relating to hydraulic hose and hose fittings with an intended use in pressure applications. Participants in the FCCTC Hydraulic Hose and Hose Fittings Subcommittee include OEMs, suppliers, consulting firms, government and other interested parties.
Reference
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.