This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Lubricant Application, Solid Film, Heat Cured, Corrosion Inhibiting
- Aerospace Standard
Published August 03, 2020 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This SAE Aerospace Standard (AS) establishes the surface pretreatment, temperature, and baking time required to cure AS5272 lubricant when it is applied over the surfaces of manufactured parts of various metals.
Paragraph 3.2.1 changed to add abrasive blast requirements.
Data Sets - Support Documents
|Unnamed Dataset 1|
|Unnamed Dataset 2|
|Unnamed Dataset 3|
E-25 General Standards for Aerospace and Propulsion Systems
The SAE E-25 General Standards for Aerospace & Propulsion Systems committee addresses aerospace propulsion systems and components. These systems and components include bolts, screws, nuts, washers, studs, rivets, pins, covers, O-rings, brackets, plugs and associated procurement requirements, as well as solid film lubricants and design specifications for screw threads and fastener assembly requirements.
|AMS2488||Anodic Treatment - Titanium and Titanium Alloys Solution pH 13 or Higher|
|AMSQQP416||Plating, Cadmium (Electrodeposited)|
|AS5272||Lubricant, Solid Film, Heat Cured, Corrosion Inhibiting Procurement Specification|
|AS8879||SCREW THREADS - UNJ PROFILE, INCH|
|ASTM D 1732||This document is not part of the subscrption.|
|ASTM D 3725||This document is not part of the subscrption.|
|ASTM F 22||This document is not part of the subscrption.|
|ASTMD1125||This document is not part of the subscrption.|
|ASTMD2510||This document is not part of the subscrption.|
|MIL-A-8625||This document is not part of the subscrption.|
|MIL-C-81302||This document is not part of the subscrption.|
|MIL-DTL-16232||This document is not part of the subscrption.|
|MIL-T-81533||This document is not part of the subscrption.|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.