This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Air and Air/Surface (Platform) Cargo Pallets
- Aerospace Standard
- AS1130
- Issued
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Aerospace Standard (AS) establishes three classes of pallets:
a. Type A, Air only Pallet
b. Type B, Platform Pallet (Air/Surface Intermodal)
c. Type C, Adapter Pallet
Pallets will have nominal dimension of:
a. Size F pallet (10 ft) (NAS 3610-2F1P) - 2.44 m x 2.99 m (96 in x 117.75 in)
b. Size R pallet (16 ft) (NAS 3610-2R1P) - 2.44 m x 4.98 m (96 in x 196 in)
c. Size G pallet (20 ft) (NAS 3610-2G1P) - 2.44 m x 6.06 m (96 in x 238.5 in)
d. Size H pallet (30 ft) (NAS 3610-2H1P) - 2.44 m x 9.12 m (96 in x 359.25 in)
e. Size J pallet (40 ft) (NAS 3610-2J1P) - 2.44 m x 12.19 m (96 in x 480 in)
Type A, Air only pallets, will normally be on aircraft equivalent roller conveying systems and/or on similarly equipped ancillary ground handling devices.
Type B, Platform pallets, are suitable for air/surface handling and transport systems. Supplementary requirements for Type B version are found in Section 4.
Type C, Adapter pallets, are used to adapt 2.44 m x 2.44 m (8 ft x 8 ft) surface mode only containers for transport. Supplementary requirements for Type C version are found in Section 5.
NOTE: Use of the adapter pallet with surface mode only 2.44 m x 2.44 m (8 ft x 8 ft) containers may require uniform load distribution on the base cross members of these containers for carriage on certain aircraft. The aircraft approved Weight and Balance Manual should be referred to for loadability procedures or limitations, or both.
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Committee AGE-2 reports to the Aerospace General Projects Division. The main, or governing committee, AGE-2, is composed of the most experienced members, mainly from the airlines, airframe manufacturers, and support equipment manufacturers, to provide leadership and guidance for the Membership to implement the work is drawn with reasonable balance from airlines, airframe manufacturers, support equipment manufacturers, and others with special aircraft related expertise. Members serve based on their knowledge, expertise, and experience and not as agents or representatives of any organization.
Reference
| Number | Title |
|---|
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.