This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Type 9 Virgin Polytetrafluoroethylene (PTFE) Moldings with Pigment for AS4716 and AS5857 Backup Rings
- Aerospace Material Specification
Published June 20, 2006 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers a polytetrafluoroethylene (PTFE) resin filled with inorganic pigment in the form of molded rods or tubes which are sintered after molding. The blue colored material is designated for use in rod glands only and the yellow colored material is designated for use in piston glands only. The brown colored material is designated for use in AS 5857 rod glands only and the green colored material is designated for use in AS 5857 piston glands only.
This document is being revised to add the materials required for back-up rings for use in AS5857 glands.
Data Sets - Support Documents
|TABLE 1||MATERIAL PROPERTY REQUIREMENTS|
AMS P Polymeric Materials Committee
Welcome to the AMS-P Polymeric & Composites Materials Committee discussion forum.The AMS-P Polymeric Materials Committee writes and revises Aerospace Material Specifications (AMS), Metric Aerospace Materials Specifications (MAM), Aerospace Recommended Practices (ARP), and Aerospace Information Reports (AIR) for composite material technology as assigned to the committee. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.