This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Polytetrafluoroethylene (PTFE) Moldings Premium Grade, As Sintered
- Aerospace Material Specification
Published May 09, 2003 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers two types of virgin, unfilled polytetrafluoroethylene (PTFE) in the form of molded rods, tubes, and shapes. This specification does not apply to product over 12 inches (305 mm) in length, rods under 0.750 inch (19.05 mm) in diameter, and tubes having wall thickness under 0.500 inch (12.70 mm).
|Aerospace Material Specification||POLYTETRAFLUOROETHYLENE MOLDINGS, GLASS FIBER FILLED 75 PTFE Resin, 25 Glass, As Sintered|
|Aerospace Material Specification||Polyamide Type 6-6, Plastic Moldings and Extrusions|
|Aerospace Material Specification||Silicone (VMQ) Rubber 1100 psi (7.58 MPa) Tensile Strength, High Resiliency 65 - 75|
Data Sets - Support Documents
|Unnamed Dataset 1|
|Unnamed Dataset 2|
|TABLE 2A||Diameter Tolerances, Inch/Pound Units|
|TABLE 2B||Diameter Tolerances, SI Units|
|TABLE 3A||Diameter Tolerances, Inch/Pound Units|
|TABLE 3B||Diameter Tolerance, SI Units|
|TABLE 4A||Maximum Out of Roundness Tolerances, Inch/Pound Units|
|TABLE 4B||Maximum Out of Roundness Tolerances, SI Units|
Welcome to the AMS-P Polymeric & Composites Materials Committee discussion forum.The AMS-P Polymeric Materials Committee writes and revises Aerospace Material Specifications (AMS), Metric Aerospace Materials Specifications (MAM), Aerospace Recommended Practices (ARP), and Aerospace Information Reports (AIR) for composite material technology as assigned to the committee. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
|AMS3660||POLYTETRAFLUOROETHYLENE MOLDINGS General Purpose Grade, As Sintered|
|ASTMD149||This document is not part of the subscrption.|
|ASTMD1708||This document is not part of the subscrption.|
|ASTMD638||This document is not part of the subscrption.|
|ASTMD638M||This document is not part of the subscrption.|
|ASTMD792||This document is not part of the subscrption.|
|MIL-STD-2073-1||This document is not part of the subscrption.|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.