This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Asbestos and Synthetic Rubber Sheet, Hot Oil Resistant
- Aerospace Material Specification
Published September 02, 2009 by SAE International in United States
AMS3232 is a compressed asbestos and synthetic rubber material. Asbestos is a hazardous material that should no longer be used. AMS3275 is a nonasbestos replacement material which works in most applications where AMS3232 was used.
|Aerospace Material Specification||Bearings, Silver Plated Steel Back|
|Aerospace Material Specification||Steel Castings, Sand, Corrosion and Moderate Heat Resistant 13Cr Normalized and Tempered|
Data Sets - Support Documents
No Datasets Available
Welcome to the AMS-CE Elastomers Committee Discussion Forum.The AMS-CE Elastomers Committee maintains Aerospace Materials Specifications (AMS), Aerospace Recommended Practices (ARP), Aerospace Information Reports (AIR) and Aerospace Standards (AS) on elastomeric materials. AMS-CE, which reports to the Aerospace Materials Division, coordinates and maintains liaison with industry, government and other standardization groups on elastomeric materials. A significant part of this committee is concerned with elastomeric fluid sealing materials, their applications, material development, testing, quality, design parameters and design practices. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
|AMS2350||STANDARD TEST METHODS|
|AMS2350B||Standards and Test Methods|
|AMS2810||IDENTIFICATION OF NATURAL AND SYNTHETIC RUBBER MATERIALS|
|ASTMD412||This document is not part of the subscrption.|
|ASTMD471||This document is not part of the subscrption.|
|ASTMD573||This document is not part of the subscrption.|
|ASTMF36||This document is not part of the subscrption.|
|ASTMF39||This document is not part of the subscrption.|
|MIL-STD-794||This document is not part of the subscrption.|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.