This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Packaging and Identification Preformed Packings
- Aerospace Material Specification
Published December 30, 2008 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers procedures which will provide protection of preformed packings, primarily “O” rings of elastomeric materials, from contamination by foreign materials prior to installation and ensure positive identification by part number of each piece until it is installed.
AMS2817F is a Five Year Review and update of this specification.
|Aerospace Material Specification||Packaging and Identification of Molded Elastomeric Seals and Sealing Components|
|Aerospace Standard||SEAL, TYPE I & II STANDARD AND LOW PROFILE|
Data Sets - Support Documents
|Unnamed Dataset 1|
|TABLE 1A||PACKAGING REQUIREMENTS, INCH/POUND UNITS|
|TABLE 1B||PACKAGING REQUIREMENTS, SI UNITS|
Welcome to the AMS-CE Elastomers Committee Discussion Forum.The AMS-CE Elastomers Committee maintains Aerospace Materials Specifications (AMS), Aerospace Recommended Practices (ARP), Aerospace Information Reports (AIR) and Aerospace Standards (AS) on elastomeric materials. AMS-CE, which reports to the Aerospace Materials Division, coordinates and maintains liaison with industry, government and other standardization groups on elastomeric materials. A significant part of this committee is concerned with elastomeric fluid sealing materials, their applications, material development, testing, quality, design parameters and design practices. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.