This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Polytetrafluoroethylene (PTFE) Resin Coating, Low Build, 370-400°C (698-752°F) Fusion
- Aerospace Material Specification
- AMS2515
- Issued
Sector:
Issuing Committee:
Language:
English
Scope
This specification establishes the engineering requirements for producing thin coatings of polytetrafluoroethylene (PTFE) resin on parts and the properties of such coatings. Primarily to provide dry lubrication, high heat stability, and corrosion protection on parts which operate at not higher than 275 degrees C (527 degrees F) for limited periods or not higher than 245 degrees C (473 degrees C) for extended periods. This coating may also be used as a release film for molds.
Recommended Content
| Aerospace Material Specification | Resin Polyurethane, Foam-In-Place, Rigid |
| Aerospace Material Specification | Shims, Filled Resin Compound, Liquid |
| Technical Paper | Relative Lifetimes of IR Absorbing and IR Transmitting Black Resins in Accelerated and Natural Weathering |
Data Sets - Support Documents
No Datasets Available
Issuing Committee
AMS P Polymeric Materials Committee
Welcome to the AMS-P Polymeric & Composites Materials Committee discussion forum.
The AMS-P Polymeric Materials Committee writes and revises Aerospace Material Specifications (AMS), Metric Aerospace Materials Specifications (MAM), Aerospace Recommended Practices (ARP), and Aerospace Information Reports (AIR) for composite material technology as assigned to the committee. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.Reference
| Number | Title |
|---|
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.