This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Molded Rigid Plastic Parts
- Aerospace Standard
Published August 24, 2011 by SAE International in United States
Downloadable datasets available
This SAE Aerospace Information Report (AIR) provides recommendations for the best practices to be followed in the molding of rigid thermoplastic and thermosetting molding compounds. The molding processes covered in this document are injection, transfer and compression molding. Recommendations are made on the design details of the part such as draft angles and processing considerations such as gate location in order to yield an easily producible, high quality, functional part.
This document has been determined to contain basic and stable technology which is not dynamic in nature.
|Aerospace Standard||Molded Rigid Plastic Parts|
|Aerospace Material Specification||POLYTETRAFLUOROETHYLENE MOLDINGS, GLASS FIBER FILLED 75 PTFE Resin, 25 Glass, As Sintered|
|Aerospace Material Specification||Rings, Butadiene-Acrylonitrile (NBR) Rubber, Molded Fuel and Low Temperature Resistant 70 - 80|
Data Sets - Support Documents
|TABLE 1||Recommended Clearance Holes|
|TABLE 2||Self-Tapping Screws for Plastics|
Welcome to the AMS-P Polymeric & Composites Materials Committee discussion forum.The AMS-P Polymeric Materials Committee writes and revises Aerospace Material Specifications (AMS), Metric Aerospace Materials Specifications (MAM), Aerospace Recommended Practices (ARP), and Aerospace Information Reports (AIR) for composite material technology as assigned to the committee. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
|ASTMD1693||This document is not part of the subscrption.|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.