This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
BOLT MACHINE-SPLINE EXTENDED WASHER, FULL SHANK, DRILLED, LONG THREAD, AMS5731, METRIC
- Aerospace Standard
- MA3342
- Reaffirmed
Downloadable datasets available
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Rationale
MA3342 HAS BEEN REAFFIRMED TO COMPLY WITH THE SAE FIVE-YEAR REVIEW POLICY.
-
1
FOR PART NUMBERS WHERE DIMENSION N IS EQUAL TO OR LESS THAN ONE TIMES THE NOMINAL DIAMETER OF THE THREAD. THE THREAD PD SHALL REPLACE DATUM B.
-
2
MATERIAL: CORROSION RESISTANT STEEL AMS 5731. (UNS S66286)
-
3
PROCUREMENT SPECIFICATION: MA 3374
-
4
HARDNESS: 26-35 HRC OR EQUIVALENT.
-
5
FLUORESCENT PENETRANT INSPECTION: AMS 2645 ACCEPTANCE CRITERIA PER MA3374
-
6
SURFACE TEXTURE: SYMBOLS PER ANSI Y14.36-1978: REQUIREMENTS PER ANSI B46.1-1985 UNLESS OTHERWISE SPECIFIED, SURFACES TO BE 3.2 MICROMETERS Ra.
-
7
PART NUMBER SHALL INCLUDE THE STANDARD NUMBER AND THE DASH NUMBER TO INDICATE DIAMETER AND LENGTH. EXAMPLE OF PART NUMBER:
MA3342-S40024 = BOLT, MJ4×0.7 THREAD, 24 LONG. MA3342-120116 = BOLT, MJ12×1.25 THREAD, 116 LONG. -
8
SHAPE OF BOTTOM OF HOLE MAY BE FLAT OR CURVED WITHIN DIMENSIONS SHOWN. NO HOLE (ØV) IS REQUIRED ON DIAMETER MJ4.
-
9
WRENCHING CONFIGURATION SHALL BE IN ACCORDANCE WITH MA1549. FOR THE APPLICABLE DASH NUMBER SEE TABLE I.
-
10
BREAK EDGES 0.1-0.4, UNLESS OTHERWISE SPECIFIED.
-
11
DIMENSIONING AND TOLERANCING: ANSI Y14.5M-1982, TOLERANCE GRADES PER ANSI B4.2-1978.
-
12
ALL DIMENSIONS IN SI MILLIMETERS UNLESS OTHERWISE SPECIFIED.
-
13
DO NOT USE UNASSIGNED PART NUMBERS.
-
MA, AS AND AMS ARE SAE PUBLICATIONS.
-
ANSI IS AMERICAN NATIONAL STANDARDS INSTITUTE PUBLICATION.
Data Sets - Support Documents
| Title | Description | Download |
|---|---|---|
| Unnamed Dataset 1 | ||
| TABLE I | ||
| Unnamed Dataset 3 | ||
| TABLE II | ||
| Unnamed Dataset 5 |
Issuing Committee
E-25 General Standards for Aerospace and Propulsion Systems
The SAE E-25 General Standards for Aerospace & Propulsion Systems committee addresses aerospace propulsion systems and components. These systems and components include bolts, screws, nuts, washers, studs, rivets, pins, covers, O-rings, brackets, plugs and associated procurement requirements, as well as solid film lubricants and design specifications for screw threads and fastener assembly requirements.
Reference
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.