This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
WINDSHIELD DEFROSTING SYSTEMS TEST PROCEDURE - TRUCKS, BUSES, AND MULTIPURPOSE VEHICLES
- Ground Vehicle Standard
- J381_198406
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice establishes uniform test procedures for the defrosting systems of enclosed cab trucks, buses, and multipurpose vehicles. It is limited to tests that can be conducted on uniform test equipment in commercially available laboratory facilities. Current engineering practice prescribes that for laboratory evaluation of defroster systems, an ice coating of known thickness be applied to the windshield to provide more uniform and repeatable test results, even though under actual conditions such a coating would necessarily be scraped off before driving. The test condition, therefore, represents a more severe condition than the actual condition, where the defroster system must merely be capable of maintaining a cleared viewing area.
Because of the special nature of the operation of most of these vehicles (where vehicles are generally warmed up before or garaged in preparation for road operations) and since defrosting under steady-state, over-the-road operations is the main concern, test conditions have been adopted which eliminate the engine warmup phase of vehicle operation.
This recommended practice will be reviewed and revised as technological progress in vehicle defroster test procedure requires.
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Truck and Bus Windshield Wipers and Climate Control Comm
The responsibility of Windshield Wipers and Climate Control Committee of the Truck and Bus Body, Occupant and Environment Steering Committee is to initiate, develop, review and approve the recommended practices, standards, and information reports related to windshield washer/wiper systems, defroster/defogging systems and components that affect the interior climate and environment of occupied areas of trucks, buses and multi purpose vehicles intended for on-highway use.
Reference
Number | Title |
---|
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.