This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Tests to Define Tire Size (Geometry), Mass, and Inertias
- Ground Vehicle Standard
- J2717_200604
- Issued
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice describes a trio of test methods which determine basic tire size (geometry), mass, and moments of inertia. The methods apply to any tire so long as the equipment is properly scaled to conduct the measurements for the intended test tire. The data are suitable for determining parameters for road load models and for comparative evaluations of the measured properties in research and development.
Rationale
This Recommended Practice was developed as part of a set of Recommended Practices intended to allow modelers to determine the parameters required by any of the common tire models for calculating spindle loads given the road surface profile from a single set of experimental results, and thus, to eliminate duplicate testing.
Recommended Content
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Vehicle Dynamics Standards Committee
The Vehicle Dynamics Standards Committee (VDSC) reports to the Vehicle Performance Steering Committee. The VDSC develops Information Reports, Recommended Practices and Standards related to the dynamics of passenger cars and light trucks, excluding trailers. The committee establishes tests and analyses that contribute to the understanding of the ride and handling performance of the total vehicle as a dynamic system.
Reference
| Number | Title |
|---|---|
| ASTM1502 | This document is not part of the subscrption. |
| FMVSS139 | This document is not part of the subscrption. |
| ISO17025 | This document is not part of the subscrption. |
| J2047_201303 | Tire Performance Terminology |
| J2047_201911 | Tire Performance Terminology |
| J2429_201509 | Free-Rolling Cornering Test for Truck and Bus Tires |
| J2710_201204 | Modal Testing and Identification of Lower Order Tire Natural Frequencies of Radial Tires |
| J2710_201709 | Modal Testing and Identification of Lower Order Tire Natural Frequencies of Radial Tires |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.