This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Disc Wheel Hub/Spoke Wheel and Axle Interface Dimensions - Truck and Bus
- Ground Vehicle Standard
- J1842_201402
- Revised
Downloadable datasets available
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice is intended for hubs and spoke wheels used on Class 6, 7, and 8 truck/truck-tractor non-powered front axles, powered and non-powered rear axles and trailer axles, for which bearing setting is manually adjusted. Assemblies using spacers to control bearing preload and endplay may differ in geometry and bearing componentry.
Rationale
The document was revised to document hub/axle configurations in common use that were previously omitted and to remove configurations no longer in common use.
Recommended Content
| Ground Vehicle Standard | Disc Wheel Hub/Spoke Wheel and Axle Interface Dimensions - Truck and Bus |
| Ground Vehicle Standard | Fatigue Test Procedures: Hubs and Wheels for Demountable Rims |
| Ground Vehicle Standard | Kingpin Wear Limits - Commercial Trailers and Semitrailers |
Topic
Data Sets - Support Documents
| Title | Description | Download |
|---|---|---|
| Unnamed Dataset 1 | ||
| Unnamed Dataset 2 |
Issuing Committee
The responsibility of the Truck and Bus Wheel Committee of the Truck and Bus Brake and Advanced Driver Assistance Systems Steering Committee is to initiate, develop, review and approve the recommended practices, standards, and information reports related to hubs, wheels and the wheel mounting systems of buses, trucks and tractor-trailer combinations intended for highway use. The Wheel Committee is constituted so as to be aware of other SAE wheel activity and to prevent duplication of effort.
Reference
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.