This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
MEASUREMENT OF FUEL EVAPORATIVE EMISSIONS FROM GASOLINE POWERED PASSENGER CARS AND LIGHT TRUCKS USING THE ENCLOSURE TECHNIQUE
- Ground Vehicle Standard
- J171_199104
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice describes a procedure for measuring evaporative emissions from fuel systems of passenger cars and light trucks. Emissions are measured during a sequence of laboratory tests that simulate typical vehicle usage in a metropolitan area during summer months:
-
a
A 1 h soak representing one diurnal cycle in which temperature of fuel in the vehicle’s tank is raised from 15.6 to 28.9 °C (60 to 84 °F)
-
b
A 17.9 km (11.1 mile) drive on a chassis dynamometer
-
c
A 1 h hot soak immediately following the 17.9 km (11.1 mile) drive
The method described in this document, commonly known as the SHED (Sealed Housing for Evaporative Determination) technique, employs an enclosure in which the vehicle is placed during the diurnal and hot soak phases of the test. Vapors that escape from all openings in the fuel system—both expected and unexpected—are retained in the enclosure, and the increase in hydrocarbon (HC) concentration of the atmosphere in the enclosure represents the evaporative emissions. Emission values measured by the enclosure method can, therefore, be significantly different than those obtained by the former trap method, depending on fuel system configuration and component design.
The test sequence and methods for measuring emissions are applicable to vehicles either with or without systems or devices to control fuel evaporative emissions. Although they have been used successfully with a wide range of vehicles equipped with a variety of control devices, they should not be applied indiscriminately to new or unique vehicles or fuel systems. For example, based on experience that temperature excursions of the fuel tank in parked vehicles follow those of ambient air, the test sequence prescribes heating of the fuel tank to simulate a diurnal soak. Any control system designed to alter the relation between fuel and ambient temperatures will not be properly evaluated in the test sequences prescribed.
This document is intended as a guide toward standard practices, but may be subject to frequent change to keep pace with experience and technical advances.
The document includes the following sections:
-
a
Definitions
-
b
Test Fuel
-
c
Test Facilities and Equipment
-
d
Measurement Method
-
e
Preparation of Test Vehicle and Fuel System
-
f
Test Sequence
-
g
Information and Data to be Recorded
-
h
Presentation of Data
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
SAE IC Powertrain Steering Committee
The Powertrain Steering Committee of the Motor Vehicle Council (MVC): evaluates the current status, prioritizes and plans future work of the group's committees. serves as the decision making body on all standards related issues to assure relevance to the industry and scope of the committee. acts as a liaison between the MVC and the group's committees as well as the Powertrain systems portion of the automotive industry and SAE. Participants in the SAE Powertrain Systems Group include OEMs, suppliers, consulting firms, government, and other interested parties.
Reference
| Number | Title |
|---|---|
| J1094 | This document is not part of the subscrption. |
| J1094_201109 | Constant Volume Sampler System for Exhaust Emissions Measurement |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.