This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Fitting—O-Ring Face Seal
- Ground Vehicle Standard
- J1453_200206
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Standard covers material, dimensional, and performance requirements of steel O-ring face seal fittings for tubing and the O-ring face seal interface and nut portion of hose stem assemblies for nominal tube or hose diameters 6.35 mm (0.250 in) through 38.1 mm (1.500 in). These fittings are intended for general application and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures. These fittings are capable of providing leak-proof full flow connections in hydraulic systems operating from 95 kPa (28 in Hg) vacuum to working pressures shown in Table 1. Since many factors influence the pressure at which a hydraulic system will or will not perform satisfactorily, these values should not be construed as guaranteed minimums. For any application, it is recommended that sufficient testing be conducted and reviewed by both the user and manufacturer to assure that required performance levels will be safe. See Figure 1.
The rated working pressure of a fluid conductor assembly using SAE J1453 hose stem connections or formed tube connection per Figure 32a, shall not exceed rated working pressure of the lowest rated component thereof.
Recommended Content
Technical Paper | FITTING PEOPLE INSIDE A MACHINE |
Technical Paper | Contamination Control in Earthmoving Machines -Hybrid Filter Elements Versus By-Pass Filters -Influence of Biodegradable Oil on Filter Life |
SAE ITC E&A Standard | AGS1100 Pipe Couplings, Typical Joints |
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Hydraulic Tube Fittings Committee
The Hydraulic Tube Fittings Subcommittee of the FCCTC develops and maintains SAE Standards, Recommended Practices and Information Reports relating to hydraulic and pneumatic tube fittings for all fluid power applications except hydraulic and pneumatic brake applications Participants in the FCCTC Hydraulic Tube Fittings Subcommittee include OEMs, suppliers, consulting firms, government and other interested parties.
Reference
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.