This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Specification for O-Ring Face Seal Connectors: Part 2 - Requirements, Dimensions, and Tests for Steel Unions, Bulkheads, Swivels, Braze Sleeves, Caps, and Connectors with ISO 6149-2 Metric Stud Ends
- Ground Vehicle Standard
Published February 14, 2007 by SAE International in United States
The JUN2002 edition of SAE J1453 was published as a single document covering the requirements for inch O-ring face seal connectors with SAE J1926-2 inch stud ends. In 1995 ISO 8434-3 was published covering the requirements for O-ring face seal connectors with ISO 6149-2 metric stud ends. This revision of SAE J1453 adopts the parts covered within ISO 8434-3 and the rationalized dimensions from ISO 8434-3 for both the inch and metric stud end face seal connectors. SAE J1453 has been organized into three sections as follows: 1. SAE J1453-1 Specifications for O-ring Face Seal Connectors-Part 1: Tube Connection Details and Common Requirements for Performance and Tests 2. SAE J1453-2 Specifications for O-ring Face Seal Connectors-Part 2: Requirements, Dimensions and Tests for Steel Unions, Bulkheads, Swivels, Braze Sleeves, Caps, and Connectors with ISO 6149-2, Metric Stud Ends 3. SAE J1453-3 Specifications for O-ring Face Seal Connectors-Part 3: Requirements, Dimensions and Tests for Steel Unions, Bulkheads, Swivels, Braze Sleeves, Caps, and Connectors with SAE J1926 Inch Stud Ends
Data Sets - Support Documents
No Datasets Available
Hydraulic Tube Fittings Committee
The Hydraulic Tube Fittings Subcommittee of the FCCTC develops and maintains SAE Standards, Recommended Practices and Information Reports relating to hydraulic and pneumatic tube fittings for all fluid power applications except hydraulic and pneumatic brake applications Participants in the FCCTC Hydraulic Tube Fittings Subcommittee include OEMs, suppliers, consulting firms, government and other interested parties.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.