This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Automotive Air Brake Hose and Hose Assemblies
- Ground Vehicle Standard
- J1402_200501
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
This recommended practice covers minimum requirements for air brake hose assemblies made from reinforced elastomeric hose and suitable fittings for use in automotive air brake systems including flexible connections from frame to axle, tractor to trailer, trailer to trailer and other unshielded air lines with air pressures up to 1 MPa, that are exposed to potential pull or impact. This hose is not to be used where temperatures, external or internal, fall outside the range of –40 °C to +100 °C.
Rationale
This document is the long overdue update of SAE J1402. Major additions, deletions and changes include the following:
-
Rationalizing all units to the preferred SI (metric) units as directed by SAE.
-
The maximum working pressure for air brake hose assemblies was defined in the Scope as 1 MPa.
-
Reference to applicable publications was added to this update.
-
This update further defines the differences between Types A, AI and AII hoses in both constructions and dimensions. Permanent and field attachable (previously known as reusable) fittings used with Type A hoses are not interchangeable with permanent and field attachable fittings used with Types AI and AII hoses due to construction and dimensional differences of the listed hoses.
-
Tables A, AI and AII were combined into a single Table 1. All other Tables were renumbered accordingly.
-
The hose layline was increased to 600 mm in order to accommodate all the labeling requirements of this standard as well as those from the applicable government regulations.
-
A note was added allowing for the labeling of hose conforming to this recommended practice with the fractional nominal inch size until January 1, 2007.
-
The table listing the radius for high temperature resistance test was deleted. All tests will use the radius listed in Table 1.
-
ASTM No. 3 oil was changed to ASTM IRM 903 oil.
Recommended Content
Ground Vehicle Standard | Automotive Air Brake Hose and Hose Assemblies |
Ground Vehicle Standard | Spherical and Flanged Sleeve (Compression) Tube Fittings |
Ground Vehicle Standard | Performance Requirements for SAE J844 Nonmetallic Air Brake Tubing and SAE J246 Compression Fitting Assemblies Used in Vehicular Air Brake Systems |
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Hydraulic Hose and Hose Fittings Committee
The Hydraulic Hose and Hose Fittings Subcommittee of the FCCTC develops and maintains SAE Standards, Recommended Practices and Information Reports relating to hydraulic hose and hose fittings with an intended use in pressure applications. Participants in the FCCTC Hydraulic Hose and Hose Fittings Subcommittee include OEMs, suppliers, consulting firms, government and other interested parties.
Reference
Number | Title |
---|---|
ASTMB117 | This document is not part of the subscrption. |
ASTMD380 | This document is not part of the subscrption. |
ASTMD413 | This document is not part of the subscrption. |
J1401 | This document is not part of the subscrption. |
J517_201612 | Hydraulic Hose |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.