This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Spoke Wheels and Hub Fatigue Test Procedures
- Ground Vehicle Standard
- J1095_200303
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice provides uniform laboratory procedures for fatigue testing of spoke wheels and hubs intended for normal highway use on trucks, buses, truck trailers, and multipurpose passenger vehicles. The hubs included have bolt circle diameters from 165.1 to 335.0 mm (6.50 to 13.19 in). It is up to each hub and/or spoke wheel developer to determine what test method, accelerated load factor and cycle life requirements are applicable to obtain satisfactory service life in a given application. When deviations from the procedures recommended herein are made, it is the responsibility of the hub and/or spoke wheel developer to modify other parameters to obtain satisfactory service life.
Recommended Content
| Technical Paper | Measurement of Multiaxial Wheel Forces and Application of the Results for the Fatigue Life Evaluation of Vehicles |
| Ground Vehicle Standard | Biaxial Wheel Fatigue Test |
| Technical Paper | An Efficient Hybrid Approach for Design of Automotive Wheel Bearings |
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
The responsibility of the Truck and Bus Wheel Committee of the Truck and Bus Brake and Advanced Driver Assistance Systems Steering Committee is to initiate, develop, review and approve the recommended practices, standards, and information reports related to hubs, wheels and the wheel mounting systems of buses, trucks and tractor-trailer combinations intended for highway use. The Wheel Committee is constituted so as to be aware of other SAE wheel activity and to prevent duplication of effort.
Reference
| Number | Title |
|---|---|
| J1835_201401 | Fastener Hardware for Wheels for Demountable Rims |
| J393_201710 | Nomenclature - Wheels, Hubs, and Rims for Commercial Vehicles |
| J694_201505 | Disc Wheel and Hub or Drum Interface Dimensions - Truck and Bus |
| J851 | This document is not part of the subscrption. |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.