This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Areas for Calculating Stress or Load Values for Externally and Internally Threaded UNJ Fasteners
- Aerospace Standard
- AS5054
- Reaffirmed
Downloadable datasets available
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Scope
This standard specifies the areas to be used in calculating stress or load values for use in externally and internally threaded fastener procurement specifications for bolts, nuts, and studs and for the information of designers.
Recommended Content
Ground Vehicle Standard | Mechanical and Material Requirements for Externally Threaded Fasteners |
Ground Vehicle Standard | Mechanical and Material Requirements for Metric Wheel Bolts |
Ground Vehicle Standard | TEST PROCEDURES FOR EVALUATING BOLT-LOAD RETENTION OF MAGNESIUM ALLOYS |
Data Sets - Support Documents
Title | Description | Download |
---|---|---|
TABLE 1 | Cross-Sectional Areas for Externally Threaded Fasteners With UNJ Threads | |
TABLE 2 | Basic Thread Data Calculations of Areas for Special Diameter Pitch Combinations of UNJ Threads |
Issuing Committee
E-25 General Standards for Aerospace and Propulsion Systems
The SAE E-25 General Standards for Aerospace & Propulsion Systems committee addresses aerospace propulsion systems and components. These systems and components include bolts, screws, nuts, washers, studs, rivets, pins, covers, O-rings, brackets, plugs and associated procurement requirements, as well as solid film lubricants and design specifications for screw threads and fastener assembly requirements.
Reference
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.