STUD - STRAIGHT, KEY LOCKED, CRES AMS5731 .250-28 UNJF X .250-28 UNJF
Published November 1, 2012 by SAE International in United States
2D/3D parts configuratorAnnotation
AS3091 HAS BEEN REAFFIRMED TO COMPLY WITH THE SAE FIVE-YEAR REVIEW POLICY. 1 MATERIAL: STUD - CORROSION AND HEAT RESISTANT STEEL, AMS 5731. KEY - CRES, AMS 5688. 2 FINISH: STUD - NONE. KEY - NONE. 3 MANUFACTURING SPECIFICATION: AMS 7477. EXCEPT BLANKS MAY BE MACHINED. REQUIREMENTS RELATED TO BOLT HEADS NOT APPLICABLE. 4 FLUORESCENT PENETRANT INSPECTION PER AMS 2645. 5 SURFACE TEXTURE: ANSI B46.1-1962. UNLESS OTHERWISE SPECIFIED, SURFACES TO BE 125 MICROINCHES (3.2 MICROMETRES). 6 DIMENSIONING AND TOLERANCING: ANSI Y14.5-1973. ∅ = DIAMETER. FORM TOLERANCES AND RELATED DATUMS ARE RFS. 7 BREAK SHARP EDGES .003–.015 (0.08–0.38) UNLESS OTHERWISE SPECIFIED. 8 DIMENSIONS IN INCHES, (MILLIMETRES), METRIC CONVERSIONS IN PARENTHESIS ARE IN INTERNATIONAL SYSTEMS UNITS (SI). 9 MARK AEROSPACE STANDARD IDENTIFICATION NUMBER AND MANUFACTURERS IDENTIFICATION ON CONTAINER. 10 DO NOT USE UNASSIGNED AEROSPACE STANDARD IDENTIFICATION NUMBERS. 11 THE INSTALLED STUD SHALL HAVE A MINIMUM RESISTANCE TO TORQUE OUT OF 90 LBF-IN (10.17 N.m). SOURCE OF SUPPLY TRIDAIR INDUSTRIES FASTENER DIVISION TORRANCE, CALIFORNIA 90505 MANUFACTURER'S CODE IDENT NO. 29372 DRAWING NO. TR15114 ONLY THE ITEM DESCRIBED ON THIS DRAWING WHEN PROCURED FROM THE VENDOR LISTED HEREON IS APPROVED FOR USE IN THE APPLICATIONS SPECIFYING THIS AEROSPACE STANDARD IDENTIFICATION NUMBER. A SUBSTITUTE ITEM SHALL NOT BE USED WITHOUT PRIOR TESTING AND APPROVAL BY THE DESIGN ACTIVITY RESPONSIBLE FOR THE APPLICATION.
Some older browsers could require a plugin install for 3D and or 2D previewer.
Data Sets - Support Documents
|[Unnamed Dataset 1]|
|[Unnamed Dataset 2]|
|[Unnamed Dataset 3]|
2 versions available
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.